Rechercher

1.1 This Standard applies to control panels and assemblies rated at not more than 1500 V, intended to be installed and used in non-hazardous locations in accordance with the rules of the Canadian Electrical Code, Part I...

Scope 1.1 This Standard applies to electric motors and generators for installation and use, in accordance with the Rules of the Canadian Electrical Code, Part I, in non-hazardous locations. Note: The term "machine" throughout...

1.1 This Standard establishes methods by which metal-enclosed equipment can be tested for resistance to the effects of arcing resulting from an internal fault. 1.2 This Standard applies only to indoor and outdoor equipment...

This Code applies to (a) the installation, servicing, and repair of propane fuel system components and containers on motor vehicles for the provision of motive power; and (b) the installation of containers, on motor vehicles...

1.1 This Standard specifies performance requirements and test methods for face protectors marketed, sold, and intended for ringette. 1.2 The intent of this Standard is to reduce the risk of injury to the face and eyes without...

1.1 This Standard specifies performance requirements and test methods for face protectors marketed, sold, and intended for ice hockey. 1.2 The intent of this Standard is to reduce the risk of injury to the face and eyes...

1.1 This Standard applies to surge protective devices (SPDs) intended for a) permanently connected applications designed for limiting surge voltages and discharging surge currents; b) use on 50/60 Hz circuits over 42 V and up...

1.1 This Standard applies to the following products designed to be employed in accordance with the Canadian Electrical Code, Part I: (a) nonmetallic outlet boxes, conduit, concrete, floor, and pull boxes that do not exceed...

1.1 This Standard applies to factory-manufactured residential, commercial, and industrial packaged terminal air-conditioners and heat pumps as defined in Clause 3. 1.2 This Standard applies to electrically operated vapour...

1. Scope 1.1 This Standard applies to shakes and shingles manufactured from western red cedar (Thuja plicata Donn ex D. Don) or Alaska (yellow) cedar (Cupressus nootkatensis D. Don). It specifies minimum grading...

1.1 General This Standard specifies performance requirements for thermostat models intended for line-voltage (120 to 240 V) switching of a controlled resistive heating load. The models covered by this Standard are as follows...

1.1 This Standard applies to ballasts for high-intensity discharge (HID) and low-pressure sodium (LPS) lamps. The HID category includes mercury vapour, metal halide, and high-pressure sodium lamps. Note: Safety requirements...