Rechercher

This Standard lays down requirements for the design qualification and type approval of terrestrial photovoltaic modules suitable for long-term operation in general open air climates, as defined in IEC 60721-2-1. This standard...

This Standard lays down requirements for the design qualification and type approval of terrestrial photovoltaic modules suitable for long-term operation in general open-air climates, as defined in IEC 60721-2-1. This document...

This Standard lays down requirements for the design qualification and type approval of terrestrial photovoltaic modules suitable for long-term operation in general open-air climates, as defined in IEC 60721-2-1. This document...

This Standard lays down requirements for the design qualification and type approval of terrestrial photovoltaic modules suitable for long-term operation in general open-air climates, as defined in IEC 60721-2-1. This document...

This Standard is intended to apply to all terrestrial flat plate module materials such as crystalline silicon module types as well as thin-film modules. The objective of this test sequence is to determine the electrical and...

New standard to address the approvals process of volumetric modular construction projects, including but not limited to: - Permitting - Facilitating Inspections - Issuing Approvals

Note: Designation Number, Standard Type and Scope updated March 27, 2018 as per a request from the responsible SDO. (NOI originally published to CNS on September 1, 2015) Note: The revised scope was withdrawn on June 5, 2018...

This Standard specifies requirements for the durability and safety of vertically installed, falling-film drain water heat recovery (DWHR) units This Standard applies to DWHR units of any diameter and length and configuration...

This standard is intended to support community paramedic workers and employers by providing curriculum requirements and guidance to perform occupational roles.

This Standard, following the principles set out in CSA Z45001, will specify requirements for a) establishing and maintaining a WAH management system in accordance with occupational health and safety management system (OHSMS)...

1 Scope 1.1 These requirements cover metallic and nonmetallic safety cans that have a maximum capacity of 5.3 US gallons (20 L) and that are intended to store and handle flammable and combustible liquids in commercial and...

In this Standard, "shall" is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; "should" is used to express a recommendation or that which is advised but...