Rechercher

1 Scope 1.1 This Standard applies to surge protective devices (SPDs) intended for: a) permanently connected applications designed for limiting surge voltages and discharging surge currents; b) use on 50/60 Hz circuits over 42 V and up to 750 V ac; c) installation between the secondary of the service transformer and the line side of the service equipment overcurrent protective device. These…

1 Scope 1.1 This Standard covers the manufacturing process and testing requirements of fibre-reinforced polymer (FRP) wet layup composite systems, pre-cured FRP plates, and FRP bars externally bonded as structural strengthening materials for structures (concrete, steel, wood, and masonry). 1.2 This Standard covers FRPs comprised of a) glass, carbon, or aramid fibres; and b) isophthalic…

Scope 1.1.1 This standard applies to newly produced, automatic storage water heaters having input ratings of 75,000 Btu/hr (21 980 W) or less (see Part IV, Definitions), hereinafter referred to as water heaters or appliances, constructed entirely of new, unused parts and materials: a. For use with natural gas; b. For use with manufactured gas; c. For use with mixed gas; d. For use…

1 Scope 1.1 This Standard establishes criteria for emergency preparedness and response for the petroleum and natural gas industry systems. Note: Prevention, continuity, and recovery are not within the scope of this Standard. 1.2 This Standard applies to petroleum and natural gas industry systems (see Figures 1 and 2), including a) pipeline systems handling i) oil; ii) gas; iii) oil-…

1 SCOPE 1.1 The requirements in this Standard apply to non-metallic raceway systems used to enclose optical fibre cables, communication cables and electrical wires and cables with combustible insulation and jackets that are rated FT4 and higher designed for use in accordance with CSA C22.1, Canadian Electrical Code, Part 1, Safety Standard for Electrical Installations, and the National…

ISO 10370:2014 specifies a method for the determination of the amount of carbon residue, in the range 0,10 % (m/m) to 30,0 % (m/m), left after evaporation and pyrolysis of petroleum products under specified conditions. NOTE 1 The carbon residue value serves as an approximation of the tendency of petroleum products to form carbonaceous deposits under similar degradation conditions, and may…

1 Scope [Add the following] The requirements of the IEC 60079 series of Standards cover protection techniques with respect to explosion hazard only. The CAN/CSA-C22.2 No. 60079 series of Standards (based on the adoption of the corresponding IEC Standards) is to be used in conjunction with other applicable Standards containing the appropriate electrical safety requirements for general-use…

ISO/IEC 10373-5:2014 defines test methods for characteristics of identification cards according to the definition given in ISO/IEC 7810. Each test method is cross‑referenced to one or more base standards, which can be ISO/IEC 7810 or one or more of the supplementary standards that define the information storage technologies employed in identification cards applications. NOTE 1 Criteria for…

ISO/IEC 10373-5:2014 defines test methods for characteristics of identification cards according to the definition given in ISO/IEC 7810. Each test method is cross‑referenced to one or more base standards, which can be ISO/IEC 7810 or one or more of the supplementary standards that define the information storage technologies employed in identification cards applications. NOTE 1 Criteria for…

Canadian deviations International Standard IEC 60384-14:2013 (fourth edition) forms the basis for CAN/CSA-E60384-14, which contains the following deviations in addition to those shown in CAN/CSA-E60384-1:14. [Replace all references to “IEC 60384-1” with “CAN/CSA-E60384-1”] 1 General 1.1 Scope [Add the following] This Standard covers the above-noted products that are intended to be…