Rechercher

This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of high-pressure cleaners without traction drive, intended for household and commercial indoor or outdoor use, having a rated...

This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of electric clothes dryers for drying textiles on racks located in a warm airflow, clothes dryers intended for drying footwear...

This clause of Part 1 is applicable except as follows: 1.1 Replacement: This part 2-14 applies to electric actuators for use in, on, or in association with equipment for household and similar use. The equipment may use...

This part of IEC 60079 specifies the general requirements for construction, testing and marking of Ex Equipment and Ex Components intended for use in explosive atmospheres. The standard atmospheric conditions (relating to the...

[Replace the first paragraph with the following] This Standard applies to fans and ventilation equipment that is a) cord-connected, rated at not more than 250 V; b) permanently connected to supply circuits of 600 V and less...

This Standard applies to controllers and starters, which may include a series mechanical switching device, intended to be connected to circuits, the rated voltage of which does not exceed 1 000 V a.c. This Standard...

This part of ISO/IEC 11770 defines key management mechanisms based on asymmetric cryptographic techniques. It specifically addresses the use of asymmetric techniques to achieve the following goals. a) Establish a shared...

This part of ISO/IEC 14496 specifies the Open Font Format (OFF) specification, the TrueType and Compact Font Format (CFF) outline formats, and the TrueType hinting language. Many references to both TrueType and PostScript...

The measurement methods and specifications are intended to be used as part of a total signal performance compliance requirement set where the phase content of the signal is involved. A more generalized concept for jitter...

1.1 Introduction This document describes the overall UPnP IoTManagementAndControl Architecture, which forms the foundation for the UPnP IoTManagementAndControl device [11] and UPnP DataStore service [13] specifications. The...

IEC 61010-2-030:2017 specifies safety requirements for equipment having testing or measuring circuits which are connected for test or measurement purposes to devices or circuits outside the measurement equipment itself. These...

This part of IEC 60079 gives requirements for the design, construction, assessment, verification and marking of rooms used to protect internal equipment: – located in a Zone 1 or Zone 2 or Zone 21 or Zone 22 explosive...