Rechercher

1.1 This Standard applies to surge protective devices (SPDs) intended for a) permanently connected applications designed for limiting surge voltages and discharging surge currents; b) use on 50/60 Hz circuits over 42 V and up...

.1 This Standard applies to Specification TC 44 portable tanks. It specifies requirements for the design and construction of such tanks. Note: The certification, assembly, modification, repair, testing, inspection and...

1.1 This Standard applies to control panels and assemblies rated at not more than 1500 V, intended to be installed and used in non-hazardous locations in accordance with the rules of the Canadian Electrical Code, Part I...

This Code applies to (a) the installation, servicing, and repair of propane fuel system components and containers on motor vehicles for the provision of motive power; and (b) the installation of containers, on motor vehicles...

1.1 This Standard provides requirements for the design, fabrication, installation, and maintenance of single-membrane structures that are either reinforced or unreinforced and that are air-supported, frame-supported, or cable...

1.1 The CSA O80 Series of Standards specifies requirements related to the preservation and fire retardance of wood through chemical treatment (pressure and thermal impregnation). The subjects covered include materials and...

1.1 General This Standard specifies performance requirements for thermostat models intended for line-voltage (120 to 240 V) switching of a controlled resistive heating load. The models covered by this Standard are as follows...

Scope 1. Scope This Standard applies to the erection and use of access scaffold that is (a) supported on a surface; (b) hung from multiple points, but is not capable of moving vertically or horizontally; or (c) mounted on...

1.1 This Standard applies to deadfront indoor enclosed and outdoor enclosed assemblies of switchgear devices such as a) switches; b) interrupting devices; c) air circuit breakers; d) power circuit breakers; and e) control...

1.1 This Standard applies to air heaters intended for use on nominal system voltages of 600 V or less and designed to be used in accordance with the Canadian Electrical Code, Part I. 1.2 This Standard applies to permanently...

1.1 This Standard establishes methods by which metal-enclosed equipment can be tested for resistance to the effects of arcing resulting from an internal fault. 1.2 This Standard applies only to indoor and outdoor equipment...

1.1 This Standard applies to the following products designed to be employed in accordance with the Canadian Electrical Code, Part I: (a) nonmetallic outlet boxes, conduit, concrete, floor, and pull boxes that do not exceed...