Rechercher

Scope This International Standard defines the encoding rules which shall apply to the representation of IPI-IIF image data. The IPI-IIF data format is defined in ISO/IEC 12087-3, called "Image Interchange Facility (IIF)". It...

This Standard covers the performance, construc- tion, testing, marking, installation, operation, and servicing of complete commerciaVindustria1 pres- sure washers and steam cleaners that are either gas- fired or oil-fired. 1...

Scope 1.1 This Standard applies to motor-operated liquid pump units for use in nonhazardous, indoor, outdoor (exposed), and submerged locations and designed to be used in accordance with the Rules of the Canadian Electrical...

Scope 1.1 This Standard consists of primary and supplementary graphic and control sets, 7-bit and 8-bit codes based on the above sets, and rules for code extension. The character sets are intended for general usage in data...

1.1 These requirements include bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code and ANSI/NFPA- 70 and Canadian Electrical Code (CEC), Part I, CSA...

1.1 General ISO/IEC ISP 10616 profiles information to be stored within the Directory which is common to a variety of applications. This International Standardized Profile augments this information with VT application specific...

IEC 60335-2-68 deals with the safety of electrical portable, non-self-propelled motor-operated spray extraction machines with or without attachments and with or without electrical heating elements, intended for commercial...

1.1 This Standard applies to factory-designed and prefabricated vapour-compression chillers that include one or more hermetic or external drive compressors. 1.2 The compressor types covered under this Standard include (a)...

1.1 This Standard specifies the test method for measuring and reporting the power consumption of small network equipment. Note: This Standard is technology neutral. 1.2 The following products are not covered by this Standard...

.1 This test method determines the wind uplift resistance of membrane-roofing systems when subjected to dynamic wind load cycles. The test methods are applicable to a) mechanically attached membrane roofing systems; and b)...

1.1 This Standard specifies the requirements for three-phase, pad-mounted distribution transformers, consisting of a transformer and a cable entrance compartment with provision for separable insulated high-voltage connectors...

This Standard applies to transportable drills, with manually fed axial movement of the spindle, having a maximum chuck capacity of 13 mm. The rated voltage is not more than 250 V for single-phase a.c. or d.c. tools, and 480 V...