Rechercher

1.1 This Standard specifies minimum design and material requirements as well as manufacturing practices and markings for prefabricated septic tanks, sewage holding tanks, and effluent chambers made of steel, concrete...

1.1 This Standard covers component assembly surge protective devices (SPDs) consisting of two or more Type 5 components, intended for use in Type 1, 2, or 3 SPD applications. 1.2 Type 4 component assemblies are designed for...

1.1 This Standard covers the requirements for dead-end/suspension composite insulators used on overhead distribution lines operating at nominal voltages up to and including 75 kV. Dead-end insulators support the line...

1.1 This Standard specifies requirements for single- and multi-conductor insulated cables having metallic interlocked armour without an overall jacket (Type AC90 or ACG90) or with an overall jacket (Type ACWU90 or ACGWU90)...

Scope This International Standard specifies methods of measurement of electrical power consumption in standby mode(s) and other low power modes (off mode and network mode), as applicable. It is applicable to electrical...

1.1 This Standard applies to high density polyethylene (HDPE) conduit, HDPE conduit with conductors, and fittings, intended for use at a continuous operating temperature of 75 °C or 90 °C, for installation in accordance with...

A3001-13 - Cementitious materials for use in concrete Scope 1.1 This Standard addresses the following aspects of cementitious materials: (a) their definitions; (b) their chemical, physical, and uniformity requirements; (c)...

Scope 1.1 General This Standard specifies design, testing, marking, and information requirements for use of full body harnesses. Full body harnesses are intended for use as body supports in personal fall arrest systems and in...

Scope 1.1 This Standard specifies design, testing, and marking requirements for manufactured fall arresters for single users and for manufactured vertical lifelines that are used on a vertical or slope plane. 1.2 The...

1.1 General This Standard applies to electric hot tubs/spas that are factory-built, self-contained packaged units supplied with equipment for heating and circulating water. These units are connected to an electrical supply...

Scope 1.1 This Code specifies requirements for the installation, alteration, and maintenance of solid-fuel-burning appliances and equipment installed indoors or outdoors. 1.2 In this Code solid-fuel-burning appliances include...

Scope 1.1 This Standard specifies design, testing, and marking requirements for manufactured fall arresters for single users and for manufactured vertical lifelines that are used on a vertical or slope plane. 1.2 The...