CSA C391:25

1 Scope 1.1 Inclusions This Standard covers three-phase, alternating current, salient pole synchronous machines 150 kW and up, 200 V to 13 800 V, at rated machine frequencies, and can assist in verifying the machine efficiency has been maintained. Note: This Standard can be useful and applied with discretion to products outside the scope of this Standard. 1.2 Exclusions Large 2-pole and 4-pole solid cylindrical rotor machines, typically used as generators for utility and large industrial applications, are excluded from this Standard. Note: See Annex D.2for information about synchronous generators. 1.3 Terminology In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy to comply with the standard; “should” is used to express a recommendation or that which is advised but not required; and “may” is used to express an option or that which is permissible within the limits of the standard. Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application. 1.4 Units of measurement The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only. All current and voltage quantities are root-mean-square (RMS) values. All formulas and measured quantities in this Standard conform to the following units unless otherwise noted: a) voltage — volts, V; b) current — amperes, A; c) power — kilowatts, kW; d) frequency — hertz, Hz; e) torque — newton-metres, N·m; f) speed — revolutions per minute, RPM; g) temperature — degrees Celsius, °C; h) time — seconds, s; and i) resistance — ohms, O.