CSA C22.2 No. 61010-2-032:25

Safety requirements for electrical equipment for measurement, control, and laboratory use — Part 2-032: Particular requirements for hand-held and hand-manipulated current sensors for electrical test and measurement Exigences de sécurité pour appareils électriques de mesurage, de régulation et de laboratoire — Partie 2-032 : Exigences particulières pour les capteurs de courant, portatifs et manipulés manuellement, pour essai électrique et mesurage
1 Scope and object IEC 61010-1:2010, Clause 1 and IEC 61010-1:2010/AMD1:2016, Clause 1 apply except as follows: 1.1.1 Equipment included in scope Replace the existing text with the following: This document specifies safety requirements for HAND-HELD and hand-manipulated current sensors intended for measuring, detecting or injecting current, or indicating current waveforms on circuits without physically opening the current path of the circuit being measured. These current sensors are hand-manipulated before and/or after a test or measurement, but are not necessarily HAND-HELD during the test or measurement. They can be stand-alone current sensors or accessories to other equipment or parts of combined equipment. These include measurement circuits which are part of electrical test and measurement equipment, laboratory equipment, or process control equipment. NOTE 1 Combined equipment is equipment that is electrically connected to a current sensor by means of a permanent connection which can be detached only by the use of a TOOL. NOTE 2 Some current sensors are also known as current clamps, CLAMP MULTIMETERS and current probes. The types of current sensors covered by this document are defined in Annex FF. 1.1.2 Equipment excluded from scope Add the following new paragraph: This document does not apply to current sensors used as FIXED EQUIPMENT. 1.2.1 Aspects included in scope Replace item c) of the second paragraph with the following new item c): c) spread of fire or arc flash from the current sensor (see Clause 9); Replace the third paragraph with the following two new paragraphs: Requirements for protection against HAZARDS arising from NORMAL USE, REASONABLY FORESEEABLE MISUSE and ergonomic factors are specified in Clause 16, Clause 101 and Annex GG. Annex BB provides guidance to equipment manufacturers on HAZARDS that should be considered for equipment intended for performing tests and measurements on hazardous conductors, including MAINS conductors and telecommunication network conductors. This Standard applies to the above-noted equipment that is intended to be installed or used in accordance with CSA C22.1, Canadian Electrical Code, Part I. General requirements applicable to the above-noted equipment are provided in CSA C22.2 No. 0.
OEN:
CSA
Langue:
English
Code(s) de l'ICS:
19.080
Statut:
Norme
Date de Publication:
2024-12-31
Numéro Standard:
CSA C22.2 No. 61010-2-032:25