Rechercher

Le présent document spécifie les exigences et les mesures de sécurité pour les machines à bois combinées (définies en 3.1), capables d’une utilisation en production continue, à chargement et déchargement manuels de la pièce et ci-après désignées également «machines». Les machines sont conçues pour la coupe de bois massif et de matériaux ayant des caractéristiques physiques similaires à celles du…

This document specifies the safety requirements and measures for manually loaded and unloaded vertical panel circular sawing machines (defined in 3.1) capable of continuous production use, with hand feed or integrated feed, hereinafter referred to also as “machines”. This document deals with all significant hazards, hazardous situations and events, as listed in Annex A, relevant to the machines,…

This document specifies the safety requirements and measures for wide belt sanding machines (defined in 3.1) and for surface treating machines (defined in 3.2) capable of continuous production use, altogether referred to as “machines”. This document deals with all significant hazards, hazardous situations and events, as listed in Annex A, relevant to the machines, when operated, adjusted and…

This document defines the functionality and behavior of the Sideband Interface responsible for connecting the Network Controller to the Management Controller. It also outlines the behavioral model of the network traffic destined for the Management Controller from the Network Controller. This document defines the following two aspects of the Network Controller Sideband Interface (NC‑SI): behavior…

This document specifies the essential dimensional features of coil-spring loaded oil control rings made of cast iron, types DSF-C, DSF-CNP, SSF, GSF, DSF, DSF-NG and SSF-L. It is applicable to piston rings in sizes from 60 mm up to and including 200 mm for reciprocating internal combustion engines for road vehicles and other applications.

This document specifies requirements for selecting the size of iron or steel wheels. It also presents formulae to determine local stresses in crane structures due to the effects of wheel loads. This document covers requirements for steel and cast-iron wheels. It applies to metallic contacts only. This document does not apply to roller bearings. This document is used together with the…

This document establishes the method of signalling the specific location referencing used by all TPEG2 applications that require detailed location information to be delivered to client devices. This document describes the TPEG2-Location Referencing Container (TPEG2-LRC) and shows how it is used to signal which specific location referencing method is in use for a particular TPEG message. It is…

This document addresses the minimum requirements for minimal risk manoeuvres (MRM), which are the response of an ADS to perform automated fallback to reach a minimal risk condition (MRC). This document specifies the classification framework for MRMs. The classification framework establishes the concept of MRM operation, classification of different MRM types, and basic principles of the decision-…

This document specifies the requirements and test methods for exterior protection for passenger cars. This document applies to passenger cars. The aim is to provide protection at the front and rear of the vehicle, of certain mechanical elements and, above all, for lighting, signals, charging ports and sensors (arranged at the front and rear of the vehicle and including but not limited to those…