Fine ceramics (advanced ceramics, advanced technical ceramics) — Test method for fracture resistance...
This document specifies a test method for determination of the fracture resistance of monolithic ceramics at room temperature using the indentation fracture (IF) method.
This document is applicable to dense monolithic ceramics and whisker- or particulate-reinforced ceramics which are regarded as macroscopically homogeneous. This document is not applicable to monolithic silicon nitride ceramics…
Determination of the residual stress of TGO layer in thermal barrier coating by photoexcitation fluo...
This document specifies a test method for the determination of the residual stress of the TGO layer in thermal barrier coating (TBC) by photoexcitation fluorescence piezoelectric spectroscopy.
This test method specifies that there is a Cr element in the bond coat of the TBC.
This test method to determine the residual stress in the TGO layer of the TBC system is not limited by the preparation…
Life cycle management of concrete structures — Part 3: Execution stage
This document specifies the management principles and procedures implemented at the execution stage under the framework of life cycle management specified by ISO 22040.
This document specifies the characteristics of laminate floor coverings, supplied in modular format e.g. tiles, planks. It also specifies requirements for marking and packaging.
Additional operational properties are given in Annex A.
Performance rating of positive displacement refrigerant compressor
This document specifies normative references, terms and definitions, rating requirements, published rating, tolerance and marking provisions of positive displacement refrigerant compressors. This document applies to positive displacement refrigerant compressors and their performance in air-conditioning, heating, refrigeration and dehumidification applications. Single stage, two-stage and…
Ships and marine technology — Hopper dredger — Suction tube position monitor
This document specifies the components, interface, technical requirements and test methods of the suction tube position monitor (STPM).
It is applicable only to the installed components, functions or systems. This document covers the design, manufacture and modifications of the suction tube position monitor.
Passive RF and microwave devices, intermodulation level measurement - Part 3: Measurement of passive...
IEC 62037-3:2025 RLV contains both the official IEC International Standard and its Redline version. The Redline version is available in English only and provides you with a quick and easy way to compare all the changes between the official IEC Standard and its previous edition.
IEC 62037-3:2025 defines the impact test on coaxial connectors to evaluate their robustness against weak connections…
Passive RF and microwave devices, intermodulation level measurement - Part 3: Measurement of passive...
IEC 62037-3:2025 defines the impact test on coaxial connectors to evaluate their robustness against weak connections and particles inside the connector, as independently as possible from the effects of cable passive intermodulation (PIM). For other connectors (e.g. panel mounted connectors), the cable can be replaced by an adequate transmission line (e.g. airline, stripline). In order to evaluate…
Dispositifs RF et à micro-ondes passifs, mesure du niveau d'intermodulation - Partie 3: Mesure ...
L’IEC 62037-3:2025 définit l’essai de choc réalisé sur des connecteurs coaxiaux pour évaluer leur robustesse dans le cas de connexions faibles et de particules à l’intérieur des connecteurs, aussi indépendamment que possible des effets de l’intermodulation passive (PIM) des câbles. Pour les autres connecteurs (par exemple les connecteurs montés sur panneaux), le câble peut être remplacé par une…
