Rechercher

This document specifies the design factor, technical requirements, test methods, installation technologies and operation advices applicable to ductile iron pipes, fittings and accessories used in piped irrigation applications. NOTE      In this document, all pressures are relative pressures expressed in bars. This document also specifies materials, dimensions and tolerances, mechanical properties…

1.1 Organization and content This standard sets out the requirements for the design, manufacture, testing and inspection of non-refillable containers with a capacity of not more than 1 L and their selection and use for the handling, offering for transport and transport of UN1950, aerosols and UN2037, gas cartridges, in Canada. This standard consists of six main sets of requirements. Sections…

1 Scope 1.1 This Standard specifies test methods and markings for flexible water connectors with excess flow shut-off devices. 1.2 The devices covered by this Standard are intended to be used in water supply systems under (a) continuous pressure in accessible locations; or (b) intermittent pressure in recreational vehicles. 1.3 In this Standard, “shall” is used to express a requirement, i.e…

1 Scope 1.1 This Standard applies to grounding and bonding equipment for use in accordance with CSA C22.1, Canadian Electrical Code, Part I in Canada, the National Electrical Code, NFPA 70, in the United States, or the Standard for Electrical Installations, NOM-001-SEDE, in Mexico. 1.2 This Standard applies to the following grounding and bonding equipment: a) ground clamps, bonding devices,…

1 Scope 1.1 This Standard specifies performance, design, testing, marking, classification, and other requirements related to anchorage connectors in travel-restraint, fall-arrest, work-positioning, and suspended component/tie-back line systems. 1.2 The requirements of this Standard include (where applicable) anchorage connectors attached to an anchorage. Methods of verifying the actual…

This document establishes general principles for the structuring of systems including structuring of information about systems. Based on these principles, rules and guidance are given for the formulation of unambiguous reference designations for objects in any system. The reference designation identifies objects for the purpose of creation and retrieval of information about an object and, where…

1 Scope This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of electrical motor-operated vacuum cleaners, including BACKPACK VACUUM CLEANERS, and DUST EXTRACTORS, for wet suction, dry suction, or wet and dry suction, intended for commercial indoor or outdoor use with or without attachments. They may be provided with a blowing or inflating function…

IEC 81346-1:2022 establishes general principles for the structuring of systems including structuring of information about systems. Based on these principles, rules and guidance are given for the formulation of unambiguous reference designations for objects in any system. The reference designation identifies objects for the purpose of creation and retrieval of information about an object and,…

1 Scope 1.1 This standard applies to bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code, ANSI/NFPA-70, and Canadian Electrical Code, Part I, CSA C22.1. 1.2 Ferrules covered by this standard are intended to facilitate the connection of stranded wire onto devices, such as terminal blocks and mechanical wire connectors…

Scope Replacement: This part of 60601 International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of HEATING DEVICES using BLANKETS, PADS or MATTRESSES in medical use, also referred to as ME EQUIPMENT. HEATING DEVICES intended to prewarm a bed are included in the scope of this document. If a clause or subclause is specifically intended to be applicable to ME EQUIPMENT only…