Additive Manufacturing of metals — Test artefacts — Compression validation coupons for lattice desig...
This document defines testing coupons and methods for the evaluation of the compression strength of AM lattice designs. The standardized test coupons will accommodate the application of a variety of lattice designs, while standardizing the evaluation method.
This document is generally intended to be used in validation or verification activities for an additively manufactured component that…
Clinical investigation of medical devices for human subjects — Good clinical practice
This document addresses good clinical practice for the design, conduct, recording and reporting of clinical investigations carried out in human subjects to assess the clinical performance or effectiveness and safety of medical devices.
For post-market clinical investigations, the principles set forth in this document are intended to be followed as far as relevant, considering the nature of the…
Additive manufacturing for medical — General principles — Additive manufacturing of non-active impla...
This document identifies factors that affect the safety and performance of surgical implants due to the fact these implants are manufactured additively.
This document applies to non-active implants manufactured additively, including custom-made implants, and patient-matched implants.
This document also applies to instrumentation for use in association with non-active surgical implants…
Agricultural vehicles — Mechanical connections on towed vehicles — Dimensions for hitch rings
This International Standard specifies dimensional requirements for the attachment of agricultural, non-balanced
trailers and implements by means of hitch rings to the rear of towing vehicles equipped with a hook specified in ISO
6489-1. Its purpose is to ensure the interchangeability of the mechanical connections on agricultural towed
vehicles.
This International Standard is applicable to rings…
Medical electrical equipment — Part 2-70: Particular requirements for basic safety and essential per...
This document is applicable to the basic safety and essential performance of sleep apnoea breathing therapy equipment, hereafter referred to as ME equipment, intended to alleviate the symptoms of patients who suffer from obstructive sleep apnoea by delivering a therapeutic breathing pressure to the respiratory tract of the patient. Sleep apnoea breathing therapy equipment is intended for use in…
Acoustics — Noise control design procedures for open plant
This International Standard defines the procedures for noise control of mainly open plants.
It is applicable to the following:
_ specification of procedures for noise control during engineering of a new plant and modification/extension of
existing plants (construction noise procedures are outside the scope of this International Standard but should
be considered);
_ definition of responsibilities…
Determination of flash point — Pensky-Martens closed cup method
ISO 2719:2016 describes three procedures, A, B and C, using the Pensky-Martens closed cup tester, for determining the flash point of combustible liquids, liquids with suspended solids, liquids that tend to form a surface film under the test conditions, biodiesel and other liquids in the temperature range of 40 °C to 370 °C.
CAUTION - For certain mixtures no flash point, as defined, is observed;…
Optics and photonics — Lasers and laser-related equipment — Vocabulary and symbols
This document defines basic terms, symbols, and units of measurement for the field of laser technology in order to unify the terminology and to arrive at clear definitions and reproducible tests of beam parameters and laser-oriented product properties.
NOTE The laser hierarchical vocabulary laid down in this document differs from that given in IEC 60825?1. ISO and IEC have discussed this…
Air cargo unit load devices — Performance requirements and test parameters
This document specifies the minimum requirements for airworthiness approval of air cargo pallets, nets and containers, generally designated as air cargo unit load devices (ULD).
This document is intended to provide a uniform technical reference for air cargo unit load devices approval. As a prerequisite, it is presupposed that the applicable general civil aviation requirements and the aircraft…
Gas cylinders — Cylinders and tubes of composite construction — Modal acoustic emission (MAE) testin...
This document describes the use of modal acoustic emission (MAE) testing during periodic inspection and testing of hoop wrapped and fully wrapped composite transportable gas cylinders and tubes, with aluminium-alloy, steel or non-metallic liners construction, intended for compressed and liquefied gases under pressure.
This document addresses the periodic inspection and testing of composite…
