Rechercher

1.1 This Standard applies to newly produced automatic valves (see Clause 3, Definitions) constructed entirely of new, unused parts and materials. These valves may be individual automatic valves or valves utilized as parts of automatic gas ignition systems. This Standard also applies to commercial/industrial safety shutoff valves (see Clause 3), herein after referred to as C/I valves. This…

1.1 This Standard applies to the construction, performance, and installation procedures for a newly produced automatic damper device (hereinafter referred to as device) constructed entirely of new, unused parts and materials and designed to control the flow or products of combustion from an individually, automatically operated, gas-fired appliance listed by a nationally recognized testing…

1.1 These requirements apply to the following stationary equipment for use in nonhazardous locations rated greater than 600 volts up to 7200 V, and remote control assemblies for such equipment: a) Heat pumps, for heating and cooling with or without factory, or field-installed electric resistance heaters, or hot water or steam heating coils; b) Air conditioners for cooling with or without…

1.1 This Standard applies to newly produced outdoor cooking gas appliances (see Clause 3) constructed entirely of new, unused parts and materials. Outdoor cooking gas appliances submitted for examination under this Standard are classified as portable, stationary, or built-in. 1.2 This Standard applies to outdoor cooking gas appliances mounted to the exterior of a recreational vehicle (RV…

1.1 This Standard is intended for manufacturers and purchasers of machinery that is sold in, imported to, or exported from Canada. It is also intended for regulators, acoustical professionals, and other interested parties. 1.2 This Standard is intended to provide a) guidance on the steps required to provide and verify noise emission declarations for machinery and equipment intended for the…

1 Scope This Standard applies to the safety of such equipment designed and constructed for installation and use in accordance with CSA C22.1, Canadian Electrical Code, Part I (CE Code, Part I). This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric appliances for use with aquariums and garden ponds for household and similar…

1.1 This Standard specifies construction and testing requirements for single conductor rated 2 kV, single metallic shielded or three conductor metallic shielded power cables rated 5 kV to 35 kV, normally used in wind turbine down tower applications where the cables are subject to frequent flexing and where installation is in accordance with the Canadian Electrical Code, Part I. 1.2 The cable…

1 Scope and object This clause of Part 1 is applicable except as follows: 1.1.1 Equipment included in scope Replacement: This part of IEC 61010 specifies safety requirements for electrically powered laboratory equipment for the heating of materials, where the heating of materials is one of the functions of the equipment. NOTE If all or part of the equipment falls within the scope of one or…

2 SCOPE This standard is intended to serve as a guide for all stakeholders taking part in the planning, use or construction of explosives magazines licensed under the Explosives Act of Canada and the Explosives Regulations, 2013 of Canada and other applicable regulations. NOTE — It is recommended that regulators be consulted during the early planning stages, and definitely before purchasing…

ISO 2061:2015 specifies a method for the determination of the direction of twist in yarns, the amount of twist, in terms of turns per unit length, and the change in length on untwisting, by the direct counting method. This International Standard is applicable to a) single yarns (spun and filament), b) plied yarns, and c) cabled yarns. Separate procedures are given for each type of yarn.…