Meteorology — Radiosonde — Part 2: Laboratory test method for errors in radiosonde humidity sensor c...
The purpose of this International Standard is to provide a test method for the calibration of radiosonde humidity sensors with varying temperature and relative humidity using laboratory setups. The main scope of this International Standard is as follows:
a) Technical requirements for laboratory setups needed for the calibration of radiosonde humidity sensors.
b) Test procedure for calibrating…
Spices and condiments — Preparation of a ground sample for analysis
Basis for this method is the laboratory sample obtained by the method specified in ISO 948. The principle of determination consists in grinding the laboratory sample, which has been previously mixed, to obtain particles of the size specified in the International Standard appropriate to the spice or condiment concerned or, if not so specified, to obtain particles of size approximately 1 mm.
Space systems — Test procedures to evaluate spacecraft material ejecta upon hypervelocity impact
ISO 11227:2012 describes an experimental procedure for assessing the behaviour, under orbital debris or meteoroid impacts, of materials that are intended to be used on the external surfaces of spacecraft and launch vehicle orbital stages. ISO 11227:2012 provides a unified method by which to rank materials. The ejecta production characteristics of different materials are compared under…
Space systems — Solar cells — Calibration procedures
This document specifies the requirements for primary and secondary calibration procedures of single-junction and multi-junction space solar cells. The main body of this international standard specifies the requirements for Air Mass Zero (AM0) standard primary and secondary calibration.
Acoustics — Noise control design procedures for open plant
This International Standard defines the procedures for noise control of mainly open plants.
It is applicable to the following:
_ specification of procedures for noise control during engineering of a new plant and modification/extension of
existing plants (construction noise procedures are outside the scope of this International Standard but should
be considered);
_ definition of responsibilities…
Information security, cybersecurity and privacy protection — A framework for identity management — P...
This document:
• provides guidelines for the implementation of systems for the management of identity information, and
• specifies requirements for the implementation and operation of a framework for identity management.
This document is applicable to any information system where information relating to identity is processed or stored."
to
“This document:
· provides…
Data structures for electronic product catalogues for building services — Part 5: Product catalogue ...
The focus of ISO 16757 is the support of manufacturers to provide their product data in electronic product catalogues.
This part of the standard – ISO 16757 Part 5: Product catalogue exchange format - describes how product catalogue data is exchanged as IFC format according to ISO 16739-1 from manufacturers to designers of building services systems.
With ISO 16739-1 (IFC), an open language…
Determination of flash point — Pensky-Martens closed cup method
ISO 2719:2016 describes three procedures, A, B and C, using the Pensky-Martens closed cup tester, for determining the flash point of combustible liquids, liquids with suspended solids, liquids that tend to form a surface film under the test conditions, biodiesel and other liquids in the temperature range of 40 °C to 370 °C.
CAUTION - For certain mixtures no flash point, as defined, is observed;…
Guidelines for addressing climate change in standards
This document provides guidance to standards developers on how to take account of climate change in the planning, drafting, revision and updating of ISO standards and other deliverables.
It outlines a framework and general principles that standards developers can use to develop their own approach to addressing climate change on a subject-specific basis.
It aims to enable standards developers to…
