Rechercher

1. Scope 1.1 This Standard sets forth the characteristics of an instrument conforming to C.I.S.P.R. requirements for the measurement of electromagnetic interference, both conducted and radiated, in the frequency range 0.15 MHz - 1000 MHz, as set for th in related CSA Standards on Tolerable Limits of Electromagnetic Interference. The frequency range, methods of use, and tolerable limits are…

This standard concerns r.f. coaxial connectors for use with r.f. cables, both flexible and semi-rigid, with air dielectric interface and high mechanical stability to withstand severe environmental exposure. The connectors provide low reflection in the microwave region up to 14 GHz and they are watertight and air-tight against a pressure difference of 3 bar.

Applies to string insulator units of the can and pin type and also of the long rod type as well as to the fittings used with such insulators. Defines dimensions of a series of clevis and tongue couplings to permit the assembly of insulators or fittings supplied by different manufacturers. Note: -For co-ordination between standardized dimensions and strength classes of cap and pin type insulators…

Characteristics of the 'parallel highway' for the CAMAC instrumentation and interface system described in IEC 60516. This highway provides for the high-speed transfer of data between CAMAC crates and computers or other controllers and for the interconnection of CAMAC crates in multicrate systems. Signal, timing and logical organization. Appendix: specifications of a standard crate…

Scope 1.1 This Standard defines fall arresting safety belts of the tongue buckle type and lanyards. It may be applied to an assembly consisting of a belt with an attached lanyard, or to a belt alone, or to a lanyard alone. Note: Requirements for quick-release and friction buckle types of belts are under study. 1.2 The equipment specified…

1. SCOPE 1.1 This Standard applies to neutral supported cables, Type NS-1 which is intended for use on systems having nominal voltages of 300 volts and less and not required to be flame retardant, and Type NSF-2 which is intended for use on systems having nominal voltages of 600 volts and less and required to be flame retardant, in accordance with the Canadian Electrical Code, Part I.…

Two methods are specified for the determination of the width of pieces (of any length) of woven fabrics that are in the state of relaxation obtained by exposure (free from applied tension) to the standard atmosphere for testing textiles. The methods are applicable to woven fabrics (including those of "stretch" type) with a minimal width of 10 cm made up full width or folded down the…

Specifies the objective criteria which make it possible to assess the value of the results obtained in each particular case. It is not intended to prescribe a type of apparatus or a procedure for converting the instrument response to concentrations units because of the broad range of equipment available and the difficulty of completely specifying all working conditions in a spectrographic…

Scope This standard describes the procedure recommended for application of cutback ashphalt plastic cement covered by 37-GP-5Ma intended for use as a general utility cement for filling and sealing joints in masonry, wood or metal building construction, for sealing and coating flashing around buildings, for embedding glass, and for repairing leaks and cracks of all types and for tabbing down…

1. Scope 1.1 This Standard covers the features of single-phase submersible transformers. For other details, reference shall be made to CSA Standard C2, Single-Phase and Three-Phase Distribution Transformers Types ONAN and LNAN, hereinafter referred to as CSA Standard C2. Note: See Appendix A, Recommendations for Corrosion Control of Submersible Transformer Installations, which covers…