Rechercher

1. Scope 1.1 This Standard covers the features of three-phase submersible transformers. For other details, reference shall be made to CSA Standard C2, Single-Phase and Three-Phase Distribution Transformers Types ONAN and LNAN, which is hereinafter referred to as CSA Standard C2. Note: Included with this Standard is Appendix A, Recommendations for Corrosion Control of Submersible…

Deals with the main areas of data processing, including the principal processes and types of equipment used, the representation, organization and presentation of data, the programming and operation of computers, input-output devices, and peripheral equipment, as well as particular applications. (Bilingual Standard - English and French versions under the same cover).

1. Scope 1.1 This Standard covers asphalt roofing in sheet form, composed of asphalt saturated roofing felt, coated at least partially on one or both faces with asphalt and surfaced with mineral matter of various particle sizes. All types are conventionally packaged in roll form.

1. Scope 1.1 This Standard applies to portable, pressurized-type, liquid petroleum fuelled lamps and lanterns with one or more burners. Note: The term device as used in this Standard refers to both lamps and lanterns, as defined in Clause 2.1. The term lamp or lantern is used where specific reference is intended. 1.2 This Standard applies to devices intended for use outdoors or…

1. Application and Scope 1.1 Application This Standard applies to devices that automatically reduce the initial supply pressure to a set lower pressure in domestic water systems. It applies to devices in the size range 1/2 - 2 inches inclusive that are of the direct acting diaphragm type with a means for adjusting the pressure setting, and are suitable for use over a hydrostatic inlet…

This is a product standard covering the properties of various grades and types of high pressure paper base decorative laminates.

1.1 Scope 1.1.1 This standard applies to newly produced automatic gas ignition systems (see Part III, Definitions) and components thereof other than types utilizing low, extra low, or high voltages, constructed entirely of new, unused parts and materials. An automatic gas ignition system shall perform the following functions: (a) Ignite the gas at the main burner(s), (b) Prove the…

This Standard applies to two types of gasoline to which no lead or phosphorus have been added and are therefore suitable for use under all climatic conditions in spark ignition engines equipped with emission control systems requiring the use of unleaded gasoline. In the interest of conservation of petroleum products it is essential that engine manufacturers continue to design engines to…

Specifies the main fixing dimensions for interchangeable shovels designed to fit tines which conform to a type specified in this standard. applies to the lower portion of tines for fixing of various types of shovels having a working width of up to 400 mm. The following fixing types are specified: type 1 - one hole; - type 2 - two holes; type 3 - two holes, heavy type.

This standard applies to trimmed drawing sheet sizes intended for the preparation of all types of technical drawings. Details of other aspects of the preparation of technical drawings can be found in Canadian Standards Association Standard B78.1 - Mechanical Engineering Drawing Standards, Drafting Practices - General Principles.