Rechercher

1. Scope 1.1 This Standard specifies the requirements for all types of welded aluminum construction, and is of general application. There are, however, special Standards which may be used for particular products, such as, pressure vessels and pipelines. 1.2 This Standard gives provisions for gas metal arc (GMAW), gas tungsten arc (GTAW), plasma arc (PAW) processes, and stud (SW )…

This National Standard of Canada is equivalent to The Institute of Electrical and Electronic Engineers Standard IEEE 404-1986. It establishes electrical ratings and test requirements for cable joints for use with extruded dielectric shielded cable rated in preferred voltage steps from 5000 V through 46 000 V and cable joints for use with laminated dielectric cable rated in preferred voltage…

This Code applies to (a) the storage, handling, transportation, and transfer of propane; (b) the installation of appliances, equipment, components, accessories and containers when propane is to be used for fuel purposes; (c) the installation of containers and equipment to be used for propane in distribution locations, filling plants, and on tank trucks, tank trailers, and cargo liners…

This National Standard of Canada is equivalent to American National Standards Institute standard ANSI T1.603-1990. In this standard, the minimal set of bearer services for the primary rate interface for the integrated services digital network (ISDN) that conforms closely to the architectural concepts described by CCITt are defined. The telecommunications environment in the United States…

This National Standard of Canada is equivalent to American National Standards Institute standard ANSI T1.604-1990. In this standard, the minimal set of bearer services for the basic rate interface for the integrated services digital network (ISDN) that conforms closely to the architectural concepts described by CCITt are defined. The telecommunications environment in the United States for…

Covers macrocomposite pipes consisting of a welded aluminum tube laminated by a melt adhesive to layers of polyethylene ins[Cide and outside the aluminum tube. The Standard also covers fittings (connectors) for use with this composite pipe. The pipes covered in this Standard are for use in potable water supply systems and are pressure rated for 1380 kPa (200 psi) at 23 degrees C and/or…

1. Scope 1.1 The Standard covers macrocomposite pipes consisting of a welded aluminum tube laminated by a melt adhesive to layers of crosslinked polyethylene inside and outside the aluminum tube. The Standard also covers fittings (connectors) for use with this composite pipe. The pipes covered in this Standard are for use in potable cold and hot water supply, central heating, and…

1.1 Applies to zinc-coated (galvanized) and aluminum-zinc alloy coated steel sheet with a factory applied finish coat, intended primarily for exterior use in residential building applications. 1.2 Intended Uses - Prefinished steel sheets covered by this standard are intended for fabrication into such building products as roll-formed windows, siding, fascia, soffits, gutters, downspouts and…

This standard applies to flat, translucent, rolled or cast glass having a pattern or figure on one or both surfaces, and used primarily in buildings for doors, windows, interior and exterior walls and for decorative purposes.

This standard applies to flat, transparent, clear sheet glass having glossy, fire-finished, apparently plane and smooth surfaces, but having a characteristic waviness of surface, for glazing, mirrors and other uses.