Design Guidelines for Telecommunications Wiring Systems in Commercial
Buildings
1. Scope
1.1
This Standard prescribes requirements covering uniform wiring systems for
telecommunications within a commercial building, up to and including the
telecommunications outlet, and between commercial buildings to the extent of a
campus type environment.
1.2
This Standard prescribes a wiring system with recommended topology and
distances.
1.3
This Standard specifies wire…
Single-Phase and Three-Phase Distribution Transformers, Types ONAN and LNAN
1.1
This Standard specifies the requirements for distribution transformers intended
primarily for operation by electric utilities.
Note: The operation of transformers complying with this Standard, by other
than an electric utility, may be subject to additional requirements by the
electrical inspection authority having jurisdiction under Part I of the
Canadian Electrical Code.
1.2
This…
Applies to hermetic refrigerant motor-compressors rated 600 V or
less, for use in air-conditioning and refrigerating equipment
that comply with the Standards applicable to such equipment.
Methods of Testing Petroleum and Associated Products Standard Test Method for
the Identification o...
1.1 This test method is a standard procedure for the determination of
paraffins, olefins, naphthenes, aromatics and unknowns (P.O.N.A.U.) in
automotive gasolines using gas chromatography.
1.2 Individual hydrocarbon components or groups of coeluting components
greater or equal to 0.01% by mass are determined.
1.3 The separation of individual hydrocarbons by the procedure described in…
Agricultural tractors — Test procedures — Part 8: Engine air cleaner
Defines the measurement accuracy. Describes the preparation and test procedure, and the results to be recorded. Annex A (test report) forms an integral part of this standard.
Banking — Procedures for message encipherment (wholesale) — Part 1: General principles
Gives terms and definitions. Defines procedures in order to protect financial messages exchanged through any communications architecture. Annex A forms an integral part of this standard. Annexes B, C and D are for information only.
Mopeds — Measurement method for moments of inertia
Defines the axis systems. Describes the equipment, the position of dummy and moped, and the measuring procedure. Annex A (format to be used for measurement results) forms an integral part of this standard.
Steel and iron — Review of available methods of analysis
Refers to the available international standard method(s) for the determination of required element(s) in steel and iron. States the field of application, the method of determination (principle), and the precision of each standard. This third edition cancels and replaces the second edition (1990).