Rechercher

Affiner les résultats
Code de la Classification internationale pour les normes (ICS)
Source
Code de l’organisme d’élaboration de normes (OEN)
Langue
Statut
Code de la Norme nationale du Canada (NNC)
Date de publication

De

à

Affichage 24581 - 24590 de 28585
Aviation Turbine Fuel, Wide Cut Type
1.1 This standard applies to two grades of wide cut type aviation turbine fuel consisting entirely of hydrocarbon compounds except as otherwise specified. 1.2 Grade JET B describes a fuel normally used in commercial operations. Grade F-40 describes a fuel used within the NATO armed forces.
Éditeur :
ONGC
Statut :
Annulée
Date de publication :
1993-05-30
Code(s) de l'ICS :
49.020; 75.160.20
Wire Connectors
1.1 This Standard applies to connectors for use with copper or aluminum conductors, or both, for providing contacts between current-carrying parts such as terminals, between lengths of wire and tap connectors, in accordance with the Canadian Electrical Code, Part I, as follows: (a) pressure wire connectors intended to hold one or more copper or aluminum conductor(s); (b) connectors…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
1993-05-30
Code(s) de l'ICS :
29.120.20
Electrical Nonmetallic Tubing
1. Scope 1.1 This Standard applies to corrugated electrical nonmetallic tubing (ENT), couplings, and fittings into which it is intended that conductors be drawn, for use in accordance with the Rules of the Canadian Electrical Code, Part I, in nonhazardous locations. 1.2 This Standard applies to products that are intended for a maximum continuous operating temperature of 75 degrees C…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
1993-05-30
Code(s) de l'ICS :
29.120.10
Recommended Practices for Electrical Protection - Electric Contact BetweenOverhead Supply and Commun...
1.1 This Standard outlines the principles and general practices of electrical protection applicable to overhead supply systems operating at more than 750 v but less than 50 kV phase to phase and communication systems, where the lines of those systems are located so that inadvertent electric contact between them could occur, resulting in a contact voltage not exceeding a limit agreed to by…
Éditeur :
CSA
Statut :
Norme
Date de publication :
1993-05-30
Code(s) de l'ICS :
13.260; 13.260
Plumbing Fittings
1.1 This Standard applies to plumbing supply fittings of NPS-1 nominal size and smaller, and plumbing waste fittings of NPS-2 nominal size and smaller. These devices include but are not limited to, the following: (a) bath and/or shower supply fittings; (b) bidet supply fittings; (c) clothes washer supply fittings; (d) drinking fountain supply fittings; (e) laundry tub supply…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
1993-05-30
Code(s) de l'ICS :
91.140.60; 91.140.70
Calcium Hypochlorite
This standard applies to calcium hypochlorite (Ca(OC1)2) intended for the sterilization of drinking water, for disinfecting, and for bleaching.
Éditeur :
ONGC
Statut :
Annulée
Date de publication :
1993-05-30
Code(s) de l'ICS :
71.060.50
Portland Cement
1.1 This Standard sets forth the definition of Portland cement; the chemical, physical, and uniformity requirements; the tests required; the procedures for inspection and sampling; the units of measurement, packaging, marking, and storage; the methods for chemical analysis and methods for physical testing; and the equipment and materials used in performing the required tests. 1.2 The…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
1993-05-30
Code(s) de l'ICS :
91.100.10
Masonry Cement
1.1 General This Standard sets forth the requirements for cement prepared specifically for use in masonry mortars.* *Masonry cement is also sold under other names: Mortar Cement, Mortar Mix (Unsanded), Masons Cement, Brick Cement, White Mortar Cement, etc. 1.2 Classification of Masonry Cement 1.2.1 Type n For use in the preparation of Type N masonry mortar, or with the use of…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
1993-05-30
Code(s) de l'ICS :
91.100.10
Blended Hydraulic Cement
1.1 Scope This Standard sets forth the definition of blended hydraulic cement; its chemical and physical requirements; the tests required; the procedures for inspection and sampling; the units of measurement; the packaging, marking, and storage; the methods for chemical analysis; the methods for physical testing; and the equipment and materials used in performing the required tests. The…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
1993-05-30
Code(s) de l'ICS :
91.100.10
Seasonal Energy Utilization Efficiencies of Oil-Fired Furnaces and Boilers
1.1 This Standard specifies the methods for determining seasonal utilization efficiency for oil-fired furnaces having an input of up to and including 66 kw (225,000 Btu/h) and boilers having an input of up to and including 88 kw (300,000 Btu/h). The tests contained in the Standard are not intended to represent actual efficiencies realized in the field. Instead, these tests provide a…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
1993-05-30
Code(s) de l'ICS :
27.060.30; 25.180.20

Spacer