Building construction — Sealants — Determination of adhesion/cohesion properties at variable tempera...
Refers to sealants with predominantly elastic behaviour. The sealant to be tested adheres to two parallel contact surfaces of the test specimens. After submission of the test specimens to extension/compression cycles under defined conditions any breaks in adhesion or cohesion are recorded.
Wood-based panels — Determination of dimensions of test pieces
Specifies a method for measuring the thickness, length and width of panels such as fibre building boards as defined in ISO 818, particle boards as defined in ISO 820 as well as plywood as defined in ISO 2074. Describes the apparatus, sampling, dimensions and conditioning of test pieces, and the procedure.
1. Scope
1.1
This Standard applies to helmets intended to provide protection for the heads
of cyclists and defines the areas of the head that are to be protected. It
covers the basic performance requirements for shock absorption and strength of
the retention system. Marking and label requirements are also included.
1.2
Detachable visors are not covered in this Standard.
CSA Safety Requirements for Electrical and Electronic Measuring and Test Equipment
1. Scope
CAN/CSA-C22.2 No. 231.0-M89 - Electrical and Electronic Measuring and Test Equipment
1.1.1 This Standard applies to electrical, electronic, or electromechanical equipment designed to
(a) measure or observe, and indicate quantities of
(i) electrical, or
(ii) electronic phenomena; or
(b) supply
(i) electrical, or
(ii) electronic quantities for measuring or…
Defines terms relating to vihicles as habitations, used for occasional occupation. Includes also definitions of some terms that affect vehicles as whole for some purposes of road use. The infomative annex A contains the bibliography. It gives the terms and definitions in English and French and finally these terms are repeated in alphabetical indexes.
Wood-based panels — Determination of moisture content
Covers fibre building boards as defined in ISO 818, particle boards as defined in ISO 820, as well as plywood as defined in ISO 2074. The principle involves the determination, by weighing, of the loss in mass of a test piece between its state at the time of sampling and its state after drying to constant mass, and the calculation of this loss in mass after drying.
Continuous mechanical handling equipment — Belt conveyors with carrying idlers — Calculation of oper...
Specifies methods for the calculation of the operating power requirements on the driving pulley of a belt conveyor, and of the tensile forces exerted on the belt. Applies to belt conveyors with carrying idlers. Lays down the definitions, symbols and units etc. and defines the resistances to motion of belt conveyor, the driving force and power requirements and the capacity and cross-section of a…
Sampling procedures and charts for inspection by variables for percent nonconforming
Is complementary to ISO 2859. Object of the methods laid down is to ensure that lots of an acceptable quality have a high probability of acceptance and that the probability of rejection of inferior lots is as high as possible. To be used under the following conditions: inspection procedure to be applied to a continuous series of lots of discrete products supplied by one producer using one…
