Rubber seals — Joint rings for water supply, drainage and sewerage pipelines — Specification for mat...
This document specifies requirements for materials used in vulcanized rubber seals for the following:
a) cold drinking-water supplies (up to 50 °C);
b) drainage, sewerage, and rainwater systems (continuous flow up to 45 °C and intermittent flow up to 95 °C).
The different designations of seals specified are defined according to their type, application, and requirements (see Table 5).…
This document specifies the minimum training to be given to trainee crane slingers and crane signallers to develop the basic slinging skills and to impart the requisite knowledge for competency required for slingers and signallers as defined in ISO 15513.
Intelligent transport systems — Automated valet parking systems (AVPS) — Part 2: Security integratio...
This document specifies security means and procedures for AVPS Type 3 as specified in ISO 23374-1. It focuses on operation interfaces and management interfaces as defined in ISO 23374-1.
Health informatics — Medical waveform format — Part 2: Electrocardiography
This document defines the application of medical waveform format encoding rules (MFER) to describe standard electrocardiography waveforms measured in physiological laboratories, hospital wards, clinics, and primary care medical checkups. It covers electrocardiography such as 12-lead, 15-lead, 18-lead, Cabrera lead, Nehb lead, Frank lead, XYZ lead, and exercise tests that are measured by…
Health informatics — Medical waveform format — Part 3: Long-term electrocardiography
This document defines the application of medical waveform format encoding rules (MFER) to describe long-term electrocardiography waveforms measured in physiological laboratories and health care clinics. It covers electrocardiography such as bipolar 2, 3-lead, 12-lead that are measured by medical equipment such as Holter electrocardiograph and patient physiological monitors that are compatible…
Road vehicles — Compressed natural gas (CNG) fuel system components — Part 23: Gas temperature senso...
This document specifies tests and requirements for gas-temperature sensors, a compressed natural gas (CNG) fuel system component intended for use on the types of motor vehicles defined in ISO 3833.
This document is applicable to vehicles (mono-fuel, bi-fuel or dual-fuel applications) using natural gas in accordance with ISO 15403-1. It is not applicable to the following:
a) liquefied…
Road vehicles — Liquefied petroleum gas (LPG) fuel system components — Part 5: Fuel selection system...
This document specifies general requirements and definitions of liquefied petroleum gas fuel components (fuel selection system and electrical installations, intended for use on the types of motor vehicles as defined in ISO 3833).
It also provides general design principles, and specifies requirements for instructions and marking.
This document is applicable to vehicles (mono-fuel, bi-fuel or dual-…
Road vehicles — Liquefied natural gas (LNG) fuel system components — Part 20: Flexible fuel or vent ...
This document specifies tests and requirements for the flexible fuel lines, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. This document is not applicable to the following:
a) fuel containers;
b) stationary gas engines;
c) container mounting hardware;
d) electronic fuel management;
e) refuelling…
Ergonomics of human-system interaction — Part 221: Human-centred design process assessment model
This document specifies the process references model (PRM) for human-centred design (HCD) according to ISO 9241-220, as well as the process assessment model (PAM) for assessing these processes, based on ISO/IEC 33020 and in accordance with the requirements of ISO/IEC 33004.
This HCD PAM contains a set of indicators to be considered while interpreting the intent of the HCD PRM defined in ISO 9241-…
