Rechercher

1 Scope and object 1.1 Scope of this Standard This Standard specifies requirements pertaining to the following: (a) definitions; (b) construction; (c) equipment complying with Standards; (d) safety and protection; (e)...

.1 This test method determines the wind uplift resistance of membrane-roofing systems when subjected to dynamic wind load cycles. The test methods are applicable to a) mechanically attached membrane roofing systems; and b)...

1.1 This series of Recommendations / International Standards defines a set of generic facilities to assist in the provision of security services in OSI applications. These include: (a) a set of notational tools to support the...

1.1 This Standard applies to a complete cablebus system (termination to termination) and associated fittings rated at not more than 46 kV and intended for use in accordance with the Canadian Electrical Code, Part I and...

1.1 This Standard applies to solid-state lighting controls rated at 600 V and less, with or without an integral switching (disconnecting) device, designed to be used in circuits a) for the control of incandescent lamps; and b...

This Recommendation | International Standard specifies the system layer of the coding. It was developed principally to support the combination of the video and audio coding methods defined in Parts 2 and 3 of ISO/IEC 13818...

This Standard specifies the system layer of the coding. It was developed principally to support the combination of the video and audio coding methods defined in Parts 2 and 3 of ISO/IEC 13818. The system layer supports six...

This Standard specifies the system layer of the coding. It was developed principally to support the combination of the video and audio coding methods defined in Parts 2 and 3 of ISO/IEC 13818. The system layer supports six...

1.1 General This Standard provides requirements for the design and evaluation of building components of fibre-reinforced polymers (FRP) in buildings and of building components reinforced with FRP materials. It is based on...

1.1 This Standard provides a calculation method for determining the heat loss and heat gain of buildings (as described in Clause 1.3 below) for the purpose of selecting the appropriate output capacity of a space heating...

1.1 This Standard specifies general requirements, test methods, and markings for whirlpool and air-jetted bathtubs and suction fittings used in hydromassage bathtub systems that incorporate a bathtub and circulation pump. The...

1.1 This Standard specifies the requirements for distribution transformers intended primarily for operation by electric utilities. Note: The operation of transformers complying with this Standard by other than an electric...