A440.4-98 (R2003)
1. Scope
1.1
This Standard sets forth methods for both new installation and replacement
installation of factory-assembled windows and exterior doors that are intended
for vertical installation in small buildings primarily used for residential
occupancy.
1.2
This Standard provides minimum requirements that will help to ensure the
installation of windows in an effective manner, such that the performance of
the window, as establshied by testing to the requirements of CSA Standards A440
and A440.2, is not compromised.
1.3
This Standard applies to the installation process from pre-installation
procedures to post-installation procedures. It does not apply to the
fabrication or assembly of units, whether such fabrication takes place in a
factory or at the installation site.
1.4
The application of this Standard requires a working knowledge of applicable
federal, provincial, and local building codes and regulations, specifically
concerning, but not limited to, required means of egress and requirements for
safety glazing.
1.5
This Standard does not apply to the
(a) selection of windows or doors for a given application;
(b) selection of other products for use in the installation;
(c) installation of windows or doors in seasonal dwellings;
(d) installation of storm windows or storm doors;
(e) maintenance of installed windows or doors, or
(f) rebuilding of windows or doors.
1.6
This Standard does not purport to address all of the safety problems associated
with its use. It does not set out requirements relating to the safety of the
person installing the units.
It is assumed that the users of this Standard are familiar with the
terminology, procedures, and requirements of good building practice.
It further assumes familiarity with sealant and sealing, glass handling
procedures, painting, where applicable, and an understanding of the
fundamentals of residential construction that affect the installation of window
and door units.
The Standard does not address the qualifications and skills that a window
installer should possess.
It is the responsibility of the users of this Standard to review and
establish appropriate safety and health practices and to determine the
applicability of regulatory limitations prior to use.
OEN:
CSA
Langue:
English
Code(s) de l'ICS:
91.060.50
Statut:
Annulée
Date de Publication:
1998-03-30
Numéro Standard:
A440.4-98 (R2003)