Road vehicles — Local Interconnect Network (LIN) — Part 2: Transport protocol and network layer serv...
This document specifies a transport protocol and network layer services tailored to meet the requirements of LIN‑based vehicle network systems on local interconnect networks. The protocol specifies an unconfirmed communication.
The LIN protocol supports the standardized service primitive interface as specified in ISO 14229-2.
This document provides the transport protocol and network layer…
Protection contre la corrosion des structures en acier par systèmes de peinture — Évaluation et crit...
Le présent document spécifie des modes opératoires permettant d’évaluer la résistance à la rupture d’un système de peinture, quelle que soit son épaisseur, appliqué sur un subjectile en acier d’épaisseur au moins égale à 3 mm. Les modes opératoires figurant dans le présent document reposent sur des méthodes d’essai utilisant différents types de machines d’essai d’arrachement par traction. Les…
Corrosion protection of steel structures by protective paint systems — Assessment of, and acceptance...
This document specifies procedures for assessing the fracture strength of a protective paint coating of any thickness on a steel substrate of thickness not less than 3 mm. The procedures given in document are based on methods used with different types of pull-off test equipment. The results obtained using such different types of equipment are not comparable.
This document is only applicable if a…
Active fibres – Characteristics and measurement methods – Guidance
IEC TR 63309: 2025, which is a Technical Report, provides an introduction of active fibres describing key characteristics and measurement methods. For the purpose of this document, an active fibre is a silica-based optical fibre doped in the core with rare-earth ions to allow optical gain, named rare-earth doped fibre. Other fibres enabling optical gain by means of different effects (e.g. Raman…
Durability test methods for electronic displays - Part 2-21: Environmental tests - Test methods for ...
IEC 63211-2-21:2025 provides test methods of the environmental tests for resistance to heat and humidity. This part of IEC 63211 is used to evaluate the ability of electronic displays to resist environmental damage. This document applies to electronic displays.
Optical fibre cables - Part 1-124: Generic specification - Basic optical cable test procedures - Mec...
IEC 60794-1-124:2025 contains test procedures, referred to as Method E24, for evaluating the behaviour of microduct cabling (microduct optical cable, fibre unit or hybrid cable etc.) when blown into a microduct or protected microduct. This document describes two blowing track layouts: Method A consists of two mandrels and two long straight sections in between (same curvature). Method B consists…
Câbles à fibres optiques - Partie 1-124: Spécification générique - Procédures fondamentales d’essais...
IEC 60794-1-124: 2025 donne les procédures d’essai, appelées Méthode E24, permettant d’évaluer le comportement d’un câblage en microconduits (câble optique en microconduits, unité de fibres, câble hybride, etc.) lors d’un soufflage appliqué dans un microconduit ou un microconduit protégé. Le présent document décrit deux dispositions de chemin de soufflage: La Méthode A se base sur deux mandrins,…
Smart city use case collection and analysis - Smart urban planning for smart cities - Part 2: Use ca...
IEC STRD 63320-2:2025 The purpose of this NP is to collect the use case of smart urban planning for smart cities, analyze the collected use cases of smart urban planning (categories analysis, functional analysis, stakeholder needs analysis, etc.), bring out the requirements of relevant standards of smart city in the future, and put forward relevant suggestions.
