Glass reinforced thermosetting plastic (GRP) pipes — Test method for determination of long-term pres...
This document specifies a method for determining the residual strength of glass-reinforced thermosetting plastics (GRP) pipes after aging the samples for a specified time at specified internal pressure and temperature. The internal environment is specified in the referring standard. The external environment can be air or water.
Anodizing of aluminium and its alloys — Assessment of quality of sealed anodic oxidation coatings by...
ISO 3210:2017 specifies methods of assessing the quality of sealed anodic oxidation coatings on aluminium and its alloys by measurement of the loss of mass after immersion in acid solution(s).
It consists of the following two methods.
- Method 1: Assessment of quality of sealed anodic oxidation coatings by measurement of the loss of mass after immersion in a phosphoric acid based solution without…
Natural gas fuelling stations — CNG stations for fuelling vehicles
ISO 16923:2016 covers the design, construction, operation, inspection and maintenance of stations for fuelling compressed natural gas (CNG) to vehicles, including equipment, safety and control devices.
ISO 16923:2016 also applies to portions of a fuelling station where natural gas is in a gaseous state and dispensing CNG derived from liquefied natural gas (LCNG) according to ISO 16924.
ISO 16923:…
Adhesives — Floor covering adhesives and products for flooring installation — Assessment and classif...
This document specifies a reference method for the determination of volatile organic compound (VOC) emissions into indoor air from floor covering adhesives and products used for flooring installation. This method is applicable to determine volatile organic compounds, semi-volatile organic compounds, and volatile aldehydes. It is based on the use of a test chamber and subsequent analysis of an air…
Paints and varnishes — Determination of resistance to cyclic corrosion conditions — Part 2: Wet (sal...
ISO 11197-2:2013 specifies a test method of determining resistance of coatings to a defined cycle of wet (salt fog)/dry/humidity/UV light conditions using a specified solution.
Fine ceramics (advanced ceramics, advanced technical ceramics) — Methods for chemical analysis of im...
This document specifies the methods for the chemical analysis of impurities in refined high purity yttrium oxide (Y2O3) powders used as a raw material for fine ceramics.
It stipulates the methods for the determination of aluminium (Al), calcium (Ca), cobalt (Co), iron (Fe) and silicon (Si) in yttrium oxide powders. Yttrium oxide powders are decomposed by microwave decomposition method. The…
Lung ventilators and related equipment — Vocabulary and semantics — Part 3: Respiratory care
This document establishes a vocabulary of terms and semantics for respiratory care not addressed in sufficient detail by ISO 19223:2019 or ISO 4135:2022.
It is applicable
— in respiratory high-flow therapy device standards
— in sleep apnoea breathing therapy device standards
— in ventilatory support device standards
— in health informatics standards
— for labelling on medical electrical…
1. Principal method
This draft specifies the principal method for laser shearography NDE inspection of FRP composites. Here, out-of-plane surface displacement gradients are monitored, using coaxial illumination and observation, both effectively perpendicular to the part surface. Defect detection relies on local influences on the global surface deformation from sub-surface anomalies under the…
Building construction machinery and equipment — Portable, hand-held, internal combustion engine-driv...
This International Standard specifies safety requirements, and measures for their verification, for the design and construction of portable, hand-held, internal combustion engine-driven machines for abrasive chains, intended to be used by a single operator in the cutting of construction materials, such as concrete, stone and metal. It is applicable only to those machines designed purposely for…
