Water meters for cold potable water and hot water — Part 5: Installation requirements
ISO 4064-5:2014 applies to water meters used to meter the volume of cold potable water and hot water flowing through a fully charged, closed conduit. These water meters incorporate devices which indicate the integrated volume.
ISO 4064-5:2014 specifies criteria for the selection of single, combination and concentric water meters, associated fittings, installation, special requirements for meters…
Plastiques — Matériaux à base de polyéthylène (PE) pour moulage et extrusion — Partie 2: Préparation...
ISO 17855-2:2016 spécifie les méthodes de préparation des éprouvettes et les méthodes d'essai à mettre en ?uvre afin de déterminer les propriétés des PE pour moulage et extrusion. Elle indique les exigences requises lors de la manipulation du matériau d'essai, ainsi que lors du conditionnement dudit matériau avant moulage et des éprouvettes avant l'essai.
Elle précise les modes…
Specifies the method for determining the ability of wire of diameter or thickness 0,3 to 10 mm inclusive to undergo plastic deformation during reverse bending. The range of diameters of thicknesses for which ISO 7801 is applicable may be more exactly specified in the relevant product standard. The test consists of repeated bending, through 90 in opposite directions, of a test piece held at one…
Glass in building — Basic soda lime silicate glass products — Part 2: Float glass
ISO 16293-2:2017 specifies dimensional and minimum quality requirements (in respect of optical and visual faults) for float glass for use in building, as defined in ISO 16293‑1.
ISO 16293-2:2017 applies to float glass supplied in stock sizes and final cut sizes.
Additive manufacturing of metals — Qualification principles — Installation, operation and performanc...
This document addresses installation qualification (IQ), operational qualification (OQ), and performance qualification (PQ) issues directly related to the additive manufacturing system that has a direct influence on the consolidation of material. The first three elements of process validation, process mapping, risk assessment, and validation planning, are necessary pre-conditions to machine…
Détermination du point d'éclair — Méthode Pensky-Martens en vase clos
ISO 2719:2016 décrit trois méthodes, A, B, et C, pour la détermination du point d'éclair des liquides combustibles, des liquides contenant des matières solides en suspension, des liquides ayant tendance à former un film en surface dans les conditions d'essai, des biocarburants et d'autres liquides, au moyen de l'appareil d'essai Pensky-Martens en vase clos, dans la plage…
