Rechercher

IEC TS 60695-11-40:2021 presents a general characterization of small-scale test flames and associated confirmatory tests based on copper block calorimetry. Guidance is presented for the selection of critical parameters in confirmatory test designs. This basic safety publication is intended for use by technical committee in the preparation of safety publications in accordance with the principles…

This document describes the state-of-the-art of prospective methods for assessing the safety performance of vehicle-integrated active safety technologies by virtual simulation. The document describes how prospective assessment of vehicle-integrated technologies provides a prediction on how advanced vehicle safety technology will perform on the roads in real traffic. The focus is on the assessment…

This document specifies MAC algorithms that use a secret key and a hash-function (or its round-function or sponge function) to calculate an m-bit MAC. These mechanisms can be used as data integrity mechanisms to verify that data has not been altered in an unauthorized manner. NOTE       A general framework for the provision of integrity services is specified in ISO/IEC 10181‑6.

This document specifies a method for the determination of water content by the Karl Fischer method. It is applicable to raw tobacco as well as tobacco taken from finished products. The method is suitable for water contents ranging from a mass fraction of at least 2 % to 55 %.

This document specifies a method for determining the mass fraction in per cent (%) of a sprayed coating powder which is deposited on a test item under known spray gun and environmental conditions. The method is applicable to powders applied by corona or tribo charging and can be used to compare the deposition efficiency of different powders with the same or different gun with the same powder.…

This document specifies a method for determining the time for a thermosetting coating powder to gel at a specified temperature. A method is described for checking batch to batch variation and for the quality control of a given coating powder. The method is not applicable to coating powders with ultra-short gel times (less than 15 s).

This document establishes a method for the estimation of the storage stability of thermosetting coating powders. It provides the procedures for determining the changes both in the physical state of a thermosetting coating powder and in its chemical reactivity, together with its capacity to form a satisfactory final coating.

This document specifies a method for the determination of density for all types of coating powders using a gas comparison pycnometer.

This document specifies a liquid displacement pycnometer method for the determination of the density of coating powders. The method is based on a determination of the mass and the volume of a test portion. Coating powders with density <1 g/cm3, can be measured in accordance with ISO 1183-1 and the appropriate method, by agreement.