Electrical installations of buildings - Part 6: Verification - Chapter 61: Initial verification
Every installation shall, during erection and/or on completion
before being put into service by the user, be visually inspected
and tested to verify, as far as practicable, that the requirements
of this standard have been met.
Magnetic tape sound recording and reproducing systems. Part 4: Mechanical magnetic tape properties
Applies to non-perforated magnetic tape used for professional and domestic analogue sound recording and reproduction. Lists and defines the methods of measurement and equipment necessary to determine the mechanical characteristics of magnetic recording tape. Will also enable users of magnetic tapes to compare technical product data of different manufacturers, produced in accordance with this…
Rubber — Determination of adhesion to rigid materials using conical shaped parts
Adhesion is obtained by a bonding system which may include not only the rigid material and the rubber compound, but other elements, e.g. thin alloy coatings etc. The bonding system should be adequately specified by the user, but the standard provides for evaluation of differnt types of failure related to a complex adhesion system. The standard test piece is given in a figure, the test report is…
Fluid Supply and Monitoring Systems for Hemodialysis
1. Scope
1.1 General
This Standard applies to
(a) reagents and apparatus for preparing dialysing fluid;
(b) monitors of the dialysing fluid;
(c) accessories for monitoring the extracorporeal blood circuit; and
(d) blood pumps, infusion, and single needle systems.
Notes:
(1) Examples of reagents and devices included within the Scope of this Standard
are dialysis concentrate and…
1. Scope and Purpose
1.1
This Standard applies to the design, installation, operation, and maintenance
of those portions of a hospital electrical system in which the interruption of
the normal supply would jeopardize the effective and safe care of its patients,
the safety of hospital staff, and the public.
1.2
This Standard includes requirements for the installation of a hospital…
Hydraulic fluid power — Filters — Statement of requirements
A statement of requirements (SOR) is defined as a document to be provided by a user to specify his requirements to a manufacturer. A model SOR is described to enable a user to define his requirements fully, without ambiguity and in standard form so that the supplier can meet the requirements as accurate as possible. Annex A contains a standard form for a SOR, annex B shows clearances.
Cranes and lifting appliances — Classification — Part 1: General
Establishes a general classification of cranes based on the number of operating cycles to be carried out during the expected life of the crane and a load spectrum factor which represents a nominal state of loading. Classification considers only the operating conditions which are independent of the type of crane and the way it is driven.
Additional information for the user:
This version uses the…
Testing Procedures for Seismic Qualification of CANDU Nuclear Power Plants
1. Scope
1.1 This Standard defines the consideration and requirements for performing an acceptable seismic qualification test and presents the different test methods that may be used.
Note: Selected safety related systems are required to be seismically qualified. (See CSA Standard CAN3-N289.1.) Qualification may be by analysis or testing, or a combination thereof, depending on the nature…
High fidelity audio equipment and systems: Minimum performancerequirements. Part 7: Loudspeakers
Applies to loudspeakers and loudspeaker systems provided with a baffle or enclosure. Also applies to systems intended to be assembled by the user (so-called 'loudspeaker kits') provided that the instructions for assembly meet certain requirements. Gives the minimum performance requirements and methods of measurement for loudspeakers and loudspeaker systems.
Water Treatment Equipment and Water Quality Requirements for Hemodialysis
Applies to:
(a) water for the preparation of dialysing fluid and concentrate
for hemodialysis;
(b) all water intended for contact with the dialysing fluid
pathway;
(c) baseline quality of the feed water and any other input water;
(d) water treatment and monitoring equipment; and
(e) water distribution system.
Users of this Standard are invited to consult the other standards
in the Z364…
