Rechercher

This document compares the requirements of selected clauses of the following standards (excluding local deviations): a) EN115‑1:2017 [12]; b) ASME A17.1/CSA B44-2016 [11]; c) Japanese Codes 2016 [13]. NOTE      The original Japanese codes were written in Japanese and no official English versions have been released. Listed Japanese codes were carefully translated, but English correspondence to the…

Le présent document spécifie les exigences relatives à la conception, la construction, l’installation et les essais des systèmes de direction mécaniques commandés à distance par câbles, et aux points d’interface entre le vérin de sortie et les gouvernails, hydrojets, moteurs hors‑bord et moteur à embase de propulsion arrière pour les petits navires. Il s’applique à trois classes distinctes de…

This document specifies design, construction, installation and test requirements for remote mechanical cable steering systems and the output ram interface point to rudders, jet drives, outboard and sterndrive engines for small craft. It is applicable to three distinct classes of steering systems for use on various types of craft: —    standard duty steering systems, for small craft with single…

This document establishes a nomenclature system for thermoplastic elastomers based on the chemical composition of the polymer or polymers involved. It specifies symbols and abbreviated terms used to identify thermoplastic elastomers in industry, commerce, and government. It is not intended to conflict with, but to supplement, existing trade names and trademarks. NOTE 1   The name of the…

Le présent document spécifie les critères de conception, les exigences techniques, les méthodes d’essai, les technologies d’installation et les recommandations d'usage applicables aux tuyaux, raccords et accessoires en fonte ductile utilisés dans le domaine des réseaux d'irrigation par canalisations sous pression. NOTE      Dans le présent document, toutes les pressions sont des…

This document specifies the design factor, technical requirements, test methods, installation technologies and operation advices applicable to ductile iron pipes, fittings and accessories used in piped irrigation applications. NOTE      In this document, all pressures are relative pressures expressed in bars. This document also specifies materials, dimensions and tolerances, mechanical properties…

1.1 Organization and content This standard sets out the requirements for the design, manufacture, testing and inspection of non-refillable containers with a capacity of not more than 1 L and their selection and use for the handling, offering for transport and transport of UN1950, aerosols and UN2037, gas cartridges, in Canada. This standard consists of six main sets of requirements. Sections…

1 Scope 1.1 This Standard specifies test methods and markings for flexible water connectors with excess flow shut-off devices. 1.2 The devices covered by this Standard are intended to be used in water supply systems under (a) continuous pressure in accessible locations; or (b) intermittent pressure in recreational vehicles. 1.3 In this Standard, “shall” is used to express a requirement, i.e…

1 Scope 1.1 This Standard applies to grounding and bonding equipment for use in accordance with CSA C22.1, Canadian Electrical Code, Part I in Canada, the National Electrical Code, NFPA 70, in the United States, or the Standard for Electrical Installations, NOM-001-SEDE, in Mexico. 1.2 This Standard applies to the following grounding and bonding equipment: a) ground clamps, bonding devices,…

1 Scope 1.1 This Standard specifies performance, design, testing, marking, classification, and other requirements related to anchorage connectors in travel-restraint, fall-arrest, work-positioning, and suspended component/tie-back line systems. 1.2 The requirements of this Standard include (where applicable) anchorage connectors attached to an anchorage. Methods of verifying the actual…