Rechercher

1 Scope 1.1 Inclusions This Standard applies to newly-produced, hand-operated quick-disconnect devices, sizes NPS 1/8 in to 1-1/2 in, hereinafter also referred to as devices, constructed entirely of new, unused parts and materials which provide a means for connecting and disconnecting appliances or appliance connectors to gas supplies, and which are for indoor and outdoor applications. These…

Scope This National Standard of Canada describes two grades of propane used for fuel purposes. These grades consist mainly of hydrocarbons containing three carbon atoms. Grade 1 is intended for use in internal combustion engines and for general industrial and commercial fuel applications. Grade 1 maintains a minimum octane quality by limiting concentrations of low-octane components (see 6.5…

Objet La présente Norme nationale du Canada s’applique à deux grades de propane utilisé comme carburant. Ces grades sont principalement constitués d’hydrocarbures comptant trois atomes de carbone. Le propane de grade 1 est destiné aux moteurs à combustion interne et peut servir de carburant dans des applications industrielles et commerciales de nature générale. Il conserve un indice d’octane…

IEC 60317-89:2023 specifies the requirements of enamelled round aluminium winding wire of class 200 with a sole coating based on polyesterimide resin, which can be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. NOTE A modified resin is a resin that has undergone a chemical change, or contains one or more additives to enhance…

IEC 60317-93: 2023 specifies the requirements of enamelled rectangular copper winding wire of class 220 with a dual coating. The underlying coating is based on polyester or polyesterimide resin, which be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. The superimposed coating is based on polyamide-imide resin. NOTE A modified…

This document gives guidance on internal investigations within organizations, including: —     the principles; —     support for investigations; —     establishment of the policy, procedures, processes and standards for carrying out and reporting on an investigation; —     the reporting of investigation results; —     the application of remedial measures. This document is applicable to all…

This document specifies the requirements for periodic inspection and testing to verify the integrity for further service of hoop-wrapped and fully-wrapped composite transportable gas cylinders and tubes, with aluminium-alloy, steel or non-metallic liners or of linerless construction (Types 2, 3, 4, and 5), intended for compressed, liquefied or dissolved gases under pressure, of water capacity…

This document specifies a method for estimating the loudness and loudness level of both stationary and time-varying sounds as perceived by otologically normal adult listeners under specific listening conditions. The sounds may be recorded using a single microphone, using a head and torso simulator, or, for sounds presented via earphones, the electrical signal delivered to the earphones may be…

This document applies to electric and electronic systems and components for vehicles including electric propulsion systems and components with maximum working voltages according to voltage class B. It describes the potential environmental stresses and specifies tests and requirements recommended for the specific mounting location on/in the vehicle. This document describes chemical loads. This…

This document specifies requirements for reference lenses for the calibration and verification of focimeters that are used for the measurement of spectacle form lenses, e.g. those complying with ISO 8598-1. It also gives a method for the determination of the back vertex power of the reference lenses. NOTE            It is accepted that other reference lenses can also be used with powers within…