Rechercher

This document specifies the requirements for periodic inspection and testing to verify the integrity for further service of hoop-wrapped and fully-wrapped composite transportable gas cylinders and tubes, with aluminium-alloy, steel or non-metallic liners or of linerless construction (Types 2, 3, 4, and 5), intended for compressed, liquefied or dissolved gases under pressure, of water capacity…

This document specifies a method for estimating the loudness and loudness level of both stationary and time-varying sounds as perceived by otologically normal adult listeners under specific listening conditions. The sounds may be recorded using a single microphone, using a head and torso simulator, or, for sounds presented via earphones, the electrical signal delivered to the earphones may be…

This document applies to electric and electronic systems and components for vehicles including electric propulsion systems and components with maximum working voltages according to voltage class B. It describes the potential environmental stresses and specifies tests and requirements recommended for the specific mounting location on/in the vehicle. This document describes chemical loads. This…

This document specifies requirements for reference lenses for the calibration and verification of focimeters that are used for the measurement of spectacle form lenses, e.g. those complying with ISO 8598-1. It also gives a method for the determination of the back vertex power of the reference lenses. NOTE            It is accepted that other reference lenses can also be used with powers within…

This document specifies requirements and recommendations for the design and execution of an interlaboratory comparison for validation of new standardized analytical methods in the field of water analysis, e.g. the number of participating laboratories and time schedules. This document is based on ISO 5725-1 and ISO 5725-2. NOTE            The scope of other standards in the field of…

This document specifies the manufacturing characteristics, the dimensions, the tolerances, the methods for quality control and delivery conditions, the measurement and the marking of hardwood and softwood raw parquet elements. NOTE       The classification of raw parquet elements according to specific characteristics and wood defects are specified, for the different species of wood, in the…

This document lists gas cylinders valve outlets in use. This document provides details of thread types and sizes. NOTE       Complete descriptions of particular valve outlets are given in national standards.

This document specifies methods to evaluate the performance of a specific class of analytical instruments, known as compliance monitoring devices (CMDs). These instruments are designed and intended to examine ballast water to determine whether a sample meets or exceeds limits for the concentration of living or viable organisms. These limits include those specified by the International Maritime…

1 Scope 1.1 General This Standard concerns high-pressure containers for the on-board storage of natural gas as a fuel for automotive vehicles. This Standard contains requirements for the material, design, manufacture, and testing of serially produced, refillable Type NGV 2 containers intended for the storage of compressed natural gas (CNG) for vehicle operation. These containers are to be…

1 Scope 1.1 General This Standard applies to the protection of workers from the hazards arising from the use of mobile or stationary machinery. It provides the criteria to be observed and the description, selection, and application of guards and protective devices. Where a current CSA standard exists for a specific type of machinery (e.g., CSA B167, CAN/CSA-B354.2, CSA M424.1, CSA Z142, CSA…