Rechercher

This part of IEC 62132 provides general information and definitions on measurement of conducted and radiated electromagnetic immunity of integrated circuits (ICs) to conducted and radiated disturbances. It also provides a description of measurement conditions, test equipment and set-up, as well as the test procedures and content of the test reports. A test method comparison table is included in…

This National Standard of Canada is based on CEI/IEC 60335-2-9:2002 + A1:2004. 1 Scope This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric portable appliances for household purposes that have a cooking function such as baking, roasting and grilling, their rated voltage being not more than 250 V. NOTE 101 Examples of appliances that…

SCOPE This standard applies to backwater valves designed to be used in drainage systems (see note) and to check valves designed to be used in drainage systems that do not drain by gravity to the building sewer, in compliance with the requirements of the National Plumbing Code of Canada - 2005. NOTE - The National Plumbing Code of Canada - 2005 defines the term drainage system as follows: "…

Consists of B137.0, B137.1, B137.2, B137.3, B137.4, B137.4.1, B137.5, B137.6, B137.8, B137.9, B137.10, B137.11 and B137.12 B137.0-05 Definitions, general requirements, and methods of testing for thermoplastic pressure piping 1 Scope 1.1 This Standard specifies requirements for thermoplastic pressure piping. It includes reference publications, definitions, abbreviations, general…

This CSA Standard is joint with both UL 486D and NMX-J-519-ANCE-05. 1 Scope 1.1 The requirements in this standard cover sealed wire connector systems, including insulating caps, covers, resins, tubing, and tapes provided with, or for use with, specific wire connectors. These systems are intended for wet or damp locations, and other installations such as direct burial, below grade, or above…

1 Scope 1.1 General This Standard specifies requirements for materials and methods for the manufacture, transportation, and installation of architectural, structural, and specialty precast concrete products. Note: This Standard should be specified for precast concrete elements used in segmental construction. 1.2 Shop drawings This Standard specifies the requirements, in addition to…

1 Scope 1.1 General This Standard covers steel valves primarily intended for use in oil or gas pipeline systems. The following types of valves are covered: (a) gate valves; (b) plug valves; (c) ball valves; and (d) check valves. 1.2 Size, nominal pressure class, and category 1.2.1 Size This Standard covers valves in sizes from NPS 2 to NPS 60. (See Table .1.) 1.2.2 Nominal pressure class This…

1 Scope This International Standard is applicable to flexible insulating covers (line hoses) for the protection of workers from accidental contact with live or earthed electrical conductors and for the avoidance of short circuits during live working. 1.1 Classes Five classes of conductor covers, differing in electrical characteristics, are provided and designated as class 0, class 1, class 2,…

ISO/TS 15883-5:2005 includes the test soils and methods that can be used to demonstrate the cleaning efficacy of washer-disinfectors (WD) according to the ISO 15883 series of standards. The inclusion of the test soils and methods in ISO/TS 15883-5:2005 does not indicate that they are of equivalent sensitivity in their determination of cleaning efficacy. Acceptance criteria are included, based…

SCOPE This standard applies to industrial products and by-products intended for use as soil amendments consistent with agronomical or silvicultural principles, and that are derived from: a) the reaction of calcium carbide with water in the production of acetylene [products and by-products essentially containing Ca(OH)2]; b) dust collecting system of lime kilns; c) the production of…