Rechercher

Scope 1.1 This Standard specifies the requirements for establishing and maintaining the certification of welding inspection organizations. 1.2 This Standard specifies the requirements for the maintenance and calibration of inspection equipment, as well as the requirements for the management of records of its welding inspection personnel and inspection records and other documents. 1.3…

1 SCOPE 1.1 This Standard sets forth minimum requirements for steel, non pressure tanks that are used for the aboveground storage of flammable and combustible liquids compatible with the material of construction and with a specific gravity not greater than 1.0. NOTE: These tanks may also be used for the storage of used oil. For tanks intended solely for the collection of used oil, refer to…

1 Scope 1.1 This Standard provides criteria for the structural design and appraisal of structures or structural elements made from wood or wood products, including graded lumber, glued-laminated timber, unsanded plywood, oriented strandboard (OSB), composite building components, shearwalls and diaphragms, timber piling, pole-type construction, prefabricated wood I-joists, structural…

This standard defines the requirements related to the specifications of an ambulance used to transport occupants, taking into account their comfort and safety. It should be taken into account that ambulances shall comply with the Canada Motor Vehicle Safety Standards (CMVSS) under Transport Canada’s Motor Vehicle Safety Act and the Motor Vehicle Safety Regulations. This document was…

C873.0-14 - Building energy estimation methodology - Part 0 - Definitions and general requirements for the calculation of energy loads, energy consumption, and source energy for heating, cooling, ventilation, domestic hot water, and lighting in buildings Scope 1.1 This Standard specifies general requirements such as reference publications, definitions, abbreviations, symbols, and subscripts…

Scope 1.1 General 1.1.1 This Standard applies to unitary air conditioners and heat pumps that are a) factory-made; b) air-source and/or air-sink; c) split-system matching assemblies (including mini-split and multi-split) or single package; d) of the type classified in Clause 1.2; e) intended for air-conditioning and space-heating applications in buildings; f) electrically driven,…

Scope 1.1 This Standard establishes requirements for newly produced compressed natural gas fuel system components, intended for use on natural gas powered vehicles, as listed in Table 1, below: Table 1 - Fuel system components - (See Clauses 1.1 and 1.5.) Check valve Manual valve Manual container valve Automatic valve Gas injector Pressure indicator Pressure regulator Gas flow…

Scope 1.1 This Standard specifies the requirements for 600 V, single-conductor, thermoplastic-insulated wires and cables, for use as follows: a) In Canada, in accordance with CSA C22.1, Canadian Electrical Code (CEC), Part I; b) In Mexico, in accordance with NOM-001-SEDE, Standard for Electrical Installations; and c) In the United States, in accordance with ANSI/NFPA 70, National Electrical…

Scope and object 1.1 Scope This part of IEC 60947 applies to the types of equipment listed in 1.1.1 and 1.1.2 whose main contacts are intended to be connected to circuits the rated voltage of which does not exceed 1 000 V a.c. or 1 500 V d.c. Starters and/or contactors dealt with in this standard are not normally designed to interrupt short-circuit currents. Therefore, suitable short-…

IEC 60317-53:2014 specifies requirements for tape wrapped rectangular copper winding wire of temperature index 220. The insulation consists of one or more wrappings of aromatic polyamide (aramid) tape of various thicknesses. The range of nominal conductor dimensions covered by this standard is: width: min. 2,00 mm max. 16,00 mm; thickness: min.0,80 mm max. 5,60 mm. This second edition cancels and…