Rechercher

1 Scope 1.1 This Standard applies to concrete block masonry units made from cementitious materials, water, and aggregates, with or without the inclusion of other materials. This Standard may be applied to other units of similar manufacture and size within the limitations of the Standard. Note: For concrete brick masonry units, see CSA A165.2. For prefaced concrete masonry units, see CSA A165…

1 Domaine d’application 1.1 Ce code vise l’installation, l’inspection, la réparation et l’entretien du système d’entreposage et de distribution de carburant qui équipe les chariots de manutention à moteur et les véhicules routiers destinés à être alimentés au gaz naturel comprimé (GNC) ou les portions au gaz naturel comprimé d’un système de gaz naturel liquéfié (GNL). Les systèmes d’…

1.1 This Standard provides minimum requirements for shop fabricated single-wall or double-wall oil-water separators intended to collect and separate free oil from water by gravity separation at an inlet free oil concentration not exceeding 2 000 mg/L. 1.2 These oil-water separators are also installed for the capture and retention of oil spills under dry weather conditions up to the free oil…

Domaine d'application 1.1 Cette norme énonce les modes opératoires et les exigences de tenue pour les lampes directionnelles standards. Note : Cette norme est neutre pour ce qui est de la technologie. 1.2 Cette norme n'énonce pas d'exigences visant les luminaires utilisés avec des lampes standards et les lampes directionnelles colorées. Notes : 1) Aux fins de la présente…

1.1 This Standard describes the requirements for the design and installation of a fire alarm system with or without voice communication capability, as defined in Section 3, Glossary. NOTE 1: This Standard is intended to apply to both required and voluntary fire alarm installations. NOTE 2: The requirements in this Standard address the installation for various types of fire alarm system…

1.1 General This Standard specifies performance requirements for thermostat models intended for line-voltage (120 to 240 V) switching of a controlled resistive heating load. The models covered by this Standard are as follows: a) wall-mounted line-voltage thermostats used with baseboards, panel convectors, fan-forced heaters or radiant floors; b) built-in line-voltage thermostats (up to 1500…

IEC 60065:2014 applies to electronic apparatus designed to be fed from the mains, from a supply apparatus, from batteries or from remote power feeding and intended for reception, generation, recording or reproduction of audio, video and associated signals. It also applies to apparatus designed to be used exclusively in combination with the above-mentioned apparatus. This standard primarily…

1.1 The requirements specified in this Standard cover light emitting diode (LED) equipment that is an integral part of a luminaire or other lighting equipment, and which operates in the visible light spectrum between 400 and 700 nm. These requirements also cover the component parts of LED equipment, including LED controlgear, controllers, arrays, modules, and packages, as defined in this Standard…

This National Standard of Canada is based on International Standard ISO 16602:2007+A1:2012, MOD. This International Standard establishes minimum performance classification and labelling requirements for protective clothing designed to provide protection against chemicals. Protective clothing items covered by this International Standard include, but may not be limited to, totally…

1.1 This Standard covers fire endurance tests applicable to walls, partitions, floors, roofs, ceilings, columns, beams, and girders, as well as to some components of these building sub-assemblies. Note: The performance displayed by a component in one assembly would not necessarily be the same when such component is tested in a dissimilar assembly. 1.2 It is the intent that the fire endurance…