Rechercher

This standard specifies the characteristics and test methods relating to pipe and fittings, manufactured from unplasticized poly(vinyl chloride) [PVC-U], with a nominal diameter smaller than or equal to 150 mm, used in underground applications for conveying wastewaters flowing by gravity. This standard applies to pipes whose wall is smooth inside and outside, fabricated by single extrusion or by…

This standard specifies the characteristics and test methods relating to pipe and fittings manufactured from unplasticized poly(vinyl chloride) [PVC-U], with a nominal diameter ranging from 200 mm to 1200 mm. This standard applies to non-perforated or perforated pipes whose wall is smooth inside and outside, fabricated by single extrusion or by multiple coextruded layers (multilayer wall), and…

ISO 14884:2015 specifies technical requirements for weathertight hinged, sliding, and pantograph doors for manual and powered operation providing access to accommodation and service areas on large yachts, taking into account the location of the appliance. This International Standard only considers design loads applied to the door and transmitted into the frame and the adjacent structure. Loads…

This standard aims to specify the requirements related to the design and manufacture of temporary canvas winter shelters for motor vehicles in order to ensure their fitness for purpose. This standard is particularly concerned with ensuring the safety of people and property by preventing the collapse or dislodgement of shelters. It takes into account snow and wind loads particular to the…

ISO 16872:2014 specifies the requirements for fine-tolerance hoist chains of grade VH for use as load chains in hand operated chain hoists for lifting purposes. They are round steel short link chains, electrically welded, heat treated, and tested; they comply with the general conditions of acceptance of ISO 1834. NOTE 1 The letter "V" expresses the grade in accordance with ISO…

ISO 16877:2014 specifies the requirements for fine-tolerance hoist chains of grade TH for use as load chains in hand operated chain hoists for lifting purposes. They are round steel short link chains, electrically welded, heat treated, and tested; they comply with the general conditions of acceptance of ISO 1834. NOTE 1 The letter "T" expresses the grade in accordance with ISO…

This part of ISO 18134 describes the method of determining the total moisture content of a test sample of solid biofuels by drying in an oven and may be used when the highest precision is not needed, e.g. for routine production control on site. The method described in this International Standard is applicable to all solid biofuels. The moisture content of solid biofuels (as received) is always…

1.1 This Standard specifies requirements for the material, analysis and design, construction, fabrication, inspection, examination, and aging management of safety-related structures for nuclear power plants. Safety-related structures covered in this Standard are a) structures that support, house, or protect nuclear safety systems; b) components of structures that are required for the safe…

1.1 This Standard applies to newly produced Type I, Type II, and Type III hose used for the transfer or conducting of propane and natural gas. 1.2 The hose and hose assemblies covered in this Standard are capable of operation at temperatures between -40°F (-40 °C) and 140°F (60 °C). 1.3 Type I hose refers to hose with a maximum operating pressure of 350 psig (2.4 MPa) and a minimum burst…

1.1 Scope [Add the following paragraphs and note] The object of this Part 1 Standard is to specify general electrical safety requirements for certain products. The requirements of this Standard apply to a specific end-use product when it is explicitly referred to by that product standard. Each individual product standard may supplement, modify, or omit a general rule in the Part 1 Standard…