Rechercher

1.1 These requirements apply to the following stationary equipment for use in nonhazardous locations rated greater than 600 volts up to 7200 V, and remote control assemblies for such equipment: a) Heat pumps, for heating and cooling with or without factory, or field-installed electric resistance heaters, or hot water or steam heating coils; b) Air conditioners for cooling with or without…

1.1 This Standard applies to newly produced outdoor cooking gas appliances (see Clause 3) constructed entirely of new, unused parts and materials. Outdoor cooking gas appliances submitted for examination under this Standard are classified as portable, stationary, or built-in. 1.2 This Standard applies to outdoor cooking gas appliances mounted to the exterior of a recreational vehicle (RV…

1.1 This Standard is intended for manufacturers and purchasers of machinery that is sold in, imported to, or exported from Canada. It is also intended for regulators, acoustical professionals, and other interested parties. 1.2 This Standard is intended to provide a) guidance on the steps required to provide and verify noise emission declarations for machinery and equipment intended for the…

1 Scope This Standard applies to the safety of such equipment designed and constructed for installation and use in accordance with CSA C22.1, Canadian Electrical Code, Part I (CE Code, Part I). This clause of Part 1 is replaced by the following. This International Standard deals with the safety of electric appliances for use with aquariums and garden ponds for household and similar…

1.1 This Standard specifies construction and testing requirements for single conductor rated 2 kV, single metallic shielded or three conductor metallic shielded power cables rated 5 kV to 35 kV, normally used in wind turbine down tower applications where the cables are subject to frequent flexing and where installation is in accordance with the Canadian Electrical Code, Part I. 1.2 The cable…

2 SCOPE This standard is intended to serve as a guide for all stakeholders taking part in the planning, use or construction of explosives magazines licensed under the Explosives Act of Canada and the Explosives Regulations, 2013 of Canada and other applicable regulations. NOTE — It is recommended that regulators be consulted during the early planning stages, and definitely before purchasing…

ISO 2061:2015 specifies a method for the determination of the direction of twist in yarns, the amount of twist, in terms of turns per unit length, and the change in length on untwisting, by the direct counting method. This International Standard is applicable to a) single yarns (spun and filament), b) plied yarns, and c) cabled yarns. Separate procedures are given for each type of yarn.…

IEC 60317-4:2015 specifies the requirements of solderable enamelled round copper winding wire of class 130 with a sole coating based on polyurethane resin, which may be modified provided it retains the chemical identity of the original resin and meets all specified wire requirements. The range of nominal conductor diameters covered by this standard is: - Grade 1: 0,018 mm up to and including 2,…

1 PURPOSE AND SCOPE This standard specifies the characteristics and test methods relating to unplasticized poly(vinyl chloride) [PVC-U] pipe having a nominal diameter ranging from 100 mm to 1500 mm. This standard applies to socket-ended pipe with gasket seals made of elastomer, with or without a restraint system integrated to the pipe, and applies to pipe without socket. These pipes are intended…

ISO 18843:2015 sets out a method for determining the amount of time taken for a given quantity of smelter-grade alumina to flow by gravity through a precisely constructed standard funnel. NOTE Variations in the apparatus and other test variables can create significant inter-laboratory differences in results. (See Table A.1.)