Rechercher

1.1 This Standard applies to all ballasts for high-intensity discharge (HID) and low-pressure sodium (LPS) lamps intended to operate with an input line frequency of 60 Hz. Note: Safety requirements for ballasts are provided in Part 2 of CAN/CSA-C22.2 No. 74. 1.2 This Standard defines the measurement technique for determining the efficiency of HID and LPS lamp ballasts for use in HID and LPS…

1.1 This Standard applies to fuel gas piping systems using corrugated stainless steel tubing (CSST), intended for installation in residential, commercial or industrial buildings, and including the following components as a minimum: a) Corrugated stainless steel tubing (CSST); b) Fittings for connection to the CSST; and c) Striker plates (see Clause 3, Definitions) to protect the installed…

1.1 This Standard specifies the design, installation, operation and maintenance of site-built and modular gaseous hydrogen fueling stations (HFS) for light duty vehicles, where light duty vehicles are defined by the Environmental Protection Agency as passenger cars and light trucks, minivans, passenger vans, pickup trucks, and sport-utility vehicles, also referred to as the “common category”…

1.1 This Standard specifies essential elements for using chemical processes to sterilize medical devices in health care settings, with the object of achieving an adequate level of sterility assurance and minimizing the risk of injury to health care setting personnel and patients. Note: The term “health care setting” includes, but is not limited to, hospitals, free standing surgical centres,…

1.1 Part 1 of this Standard applies to ballasts of the resistance, reactance, and electronic (solid state) types for use with fluorescent lamps, involving potentials of 2500 V to ground or less during either starting or running conditions, whether intended for mounting in a luminaire or otherwise, and designed to be employed on circuits of not more than 600 V between supply conductors in…

1.1 This Standard applies to commercial, industrial, and institutional electric clothes-drying equipment intended to be used by trained or supervised personnel only, in nonhazardous locations in accordance with the Canadian Electrical Code, Part I (CEC) on circuits having a nominal voltage not exceeding 600 V. Note: Wherever practical, for convenience, the term ?appliance? has been used in…

1.1 This Standard applies to the selection of materials for, and the fabrication and installation of, permanent wood foundations. 1.2 Specific details are provided for buildings up to three storeys in building height above the foundation and having a building area not exceeding 600 m2. 1.3 This Standard provides for the optional use of wood sleeper, poured concrete slab, and suspended wood…

1.1 This Standard sets forth minimum requirements for hose and hose assemblies, including coaxial vapour recovery hose and hose assemblies, for use on dispensing devices for flammable and combustible liquids. 1.2 This Standard does not cover hose or hose assemblies for aircraft refuelling service. 1.3 This Standard does not cover hose or hose assemblies intended for use as a component in…

1.1 Organization and content This standard sets out requirements for designing, manufacturing and marking of Intermediate Bulk Containers (IBCs) and for selecting and using means of containment for the transportation of dangerous goods of classes 3, 4, 5, 6.1, 8 and 9. This standard consists of two parts and four annexes. Part I contains the requirements for the design and manufacture of UN…

ISO 15753:2016 describes two methods for the determination of 15 polycyclic aromatic hydrocarbons (PAHs) in animal and vegetable fats and oils: - a general method; - a specific method for coconut oil and vegetable oils with short-chain fatty acids. These methods are not quantitative for the very volatile compounds such as naphthalene, acenaphthene and fluorene. Due to interferences…