Rechercher

1.1 This Standard applies to mechanical flue-gas exhausters intended to be installed in a flue pipe, breeching, or chimney and serving appliances burning natural gas, propane, or fuel oil. 1.2 This Standard covers the mechanical and electrical features of mechanical flue-gas exhausters for indoor or outdoor installations. 1.3 This Standard classifies mechanical flue-gas exhausters as: a)…

1.1 This Standard applies to plugs, receptacles, power inlets and outlets, connectors, and similar wiring devices intended for use in electronic and electrical applications in accordance with the Canadian Electrical Code, Part I. The types covered are as follows (see Figure 3): a) Type 0 rated up to 8.3 A and up to 30 V rms (42 V peak); b) Type 1A rated up to 8.3 A and from 30 V to 600 V ac…

1.1 This Standard specifies criteria to develop emission reduction practices and programs. 1.2 This Standard addresses fugitive and vented emissions from point sources in the following sectors (see Figure 1) of the upstream oil and gas industry from wells, pipelines, and facilities associated with a) crude oil production and shale oil; b) oil sands – in situ bitumen production, including…

1.1 This International Standard specifies requirements and guidelines for the design, manufacture, installation, function, performance, maintenance, servicing, documentation, testing, and commissioning of equipment for evacuation of plume generated by medical devices. NOTE A plume evacuation system (PES) can be a functionally independent component of a medical device that has other functions. 1.2…

ISO 80369-3:2016 specifies the dimensions and requirements for the design and functional performance of small-bore connectors intended to be used for connections on enteral medical devices and accessories. NOTE 1 Enteral medical devices include enteral feeding sets, enteral drainage sets, enteral syringes, and patient interface devices including access ports. It does not specify the dimensions…

1.1 This Standard applies to wet-process porcelain and toughened glass suspension-type insulators used on ac overhead power lines with a nominal voltage greater than 1000 V and a frequency not greater than 100 Hz. This Standard applies to single insulator units only and does not apply to long rod insulators. 1.2 This Standard specifies provisions for a) the mechanical, electrical, and…

1.1 This Standard covers the requirements for dead-end/suspension composite insulators used on overhead distribution lines operating at nominal voltages up to and including 75 kV. Dead-end insulators support the line conductor horizontally. Suspension insulators support the line conductor vertically. Both are subjected to tensile and torsional loads. These composite insulators are intended to…

1.1 This Standard covers the requirements for line post composite insulators used on overhead distribution lines operating at nominal voltages up to and including 75 kV. Line post insulators support the line conductor horizontally or vertically. They are subjected to tensile, cantilever, and compressive loads. These composite insulators are intended to operate in a service environment within a…

ISO 10254:2016 defines the terms relating to air cargo and aircraft ground equipment, as used in the other International Standards in these areas. NOTE The term "weight" is used throughout ISO 10254:2016 instead of the correct technical term "mass", in order to conform to current commercial usage. The terms and abridged definitions of ISO 10254:2016 are primarily…

ISO/TS 19880-1:2016 recommends the minimum design characteristics for safety and, where appropriate, for performance of public and non-public fuelling stations that dispense gaseous hydrogen to light duty land vehicles (e.g. Fuel Cell Electric Vehicles). NOTE These recommendations are in addition to applicable national regulations and codes, which can prohibit certain aspects of this…