Rechercher

This National Standard of Canada is equivalent to International Standard ISO/TS 16949:1999 (first edition, 1999-03-01). 1. Scope This Technical Specification specifies, in conjunction with ISO 9001:1994, the quality system requirements for the design/development, production and, when relevant, installation and servicing of automotive-related products. This Technical Specification is…

This National Standard of Canada is based on International Standard CEI/IEC 1264:1994. 1 General 1.1 Scope This standard applies to hollow insulators made of ceramic metarial, with their fixing devices, intended for use with a permanent gas pressure greater than 0,5 bar having an internal volume equal to or greater than 1 litre (1 000 cm³). They are intended for use in electrical…

This National Standard of Canada is based on Standard ANSI/WCMA A100.1-1996. 1. SCOPE & FOREWORD 1.1 The members of the Window Covering Manufacturers Association, Inc. (WCMA), recognizing that unfortunate accidents, including strangulation, have occured among young children using certain products having flexible loops made or imported by members of the industry, have prepared this…

This National Standard of Canada is equivalent to International Standard CEI/IEC 609000: 1987. 1. Scope This standard is applicable to insulating poles (insulating sticks) and tool attachments (fittings) and is divided into three chapters. Chapter I: Specifies the required characteristics for insulating poles with permanently attached fittings and the tests (…

This National Standard of Canada is equivalent to International Standard CEI/IEC 60900: 1987. 1 Scope This standard is applicable to insulated and insulating hand tools used for working live or close to live parts at nominal voltages up to 1 000 V a.c. and 1 500 V d.c. Not included are : - tools and equipment and material supplied from an external energy source…

This National Standard of Canada is based on International Standard CEI/IEC 61230: 1993. 1 Scope This International Standard is applicable to portable equipment, with or without matching fixed connection points, for temporary earthing or earthing and short-circuiting of electrically isolated a.c. transmission and distribution systems, including railway systems, for the protection of…

This National Standard of Canada is equivalent to International Standard CEI/IEC 61236: 1993. 1.1 Scope This International Standard is applicable to saddles and pole clamps (stick clamps) used for live working, and to their accessories. It specifies: - the dimensional and mechanical characteristics to be given by the manufacturer for each tool; - the…

1.1 Scope 1.1.1 This standard applies to newly produced, direct gas-fired industrial air heaters of the non-recirculating type, hereinafter referred to as heaters, whose purpose is to offset building heat loss. All air to the heater shall be ducted directly from outdoors and the products of combustion generated by the heater are released into the air stream being heated. Heaters covered by…

This National Standard of Canada is based on International Standard CEI/IEC 60900: 1987. 1. Scope This Standard is applicable to insulated and insulating hand tools used for working live or close to live parts at nominal voltages up to 1,000 V a.c or 1,500 V d.c. Not included are: - tools and equipment and material supplied from an external energy source; - insulating rods and poles…

This National Standard of Canada is equivalent to International Standard ISO 14024:1999. 1 Scope This International Standard establishes the principles and procedures for developing Type I environmental labelling programmes, including the selection of product categories, product environmental criteria and product function charateristics; and for assessing and demonstrating compliance.…