Rechercher

This National Standard of Canada is equivalent to International Standard IEC 60601-2-41:2000 (first edition, 2000-02). 1 Scope and object This clause of the General Standard applies except as follows: *1.1 Scope Addition: This Particular Standard details the requirements to be applied to SURGICAL LUMINAIRES and LUMINAIRES FOR DIAGNOSIS as defined in 2.101 to 2.105, hereinafter referred to as…

This National Standard of Canada is equivalent to International Standard ISO/IEC 10026-4:1995. 1 Scope This Recommendation | International Standard provides the PICS proforma for the Distributed Transaction Processing protocol as specified in ITU-T Rec. X.862 | ISO/IEC 10026-3 in compliance with the relevant requirements, and in accordance with the relevant guidance, given in CCITT…

This National Standard of Canada is equivalent to International Standard ISO/IEC 10116:1991. 1 Scope This International Standard describes four modes of operation for an n-bit block cipher algorithm. NOTE 1 Annex A (informative) contains comments on the properties of each mode. This International Standard establishes four defined modes of operation so that in applications of an n-…

This National Standard of Canada is based on International Standard IEC 60335-2-21:1997, (fourth edition 1997-08), including Amendment 1:1999. 1 Scope This clause of part 1 is replaced by: This standard deals with the safety of electric storage water heaters for household and similar purposes and intended for heating water below boiling temperature, their rated voltage being not more…

This National Standard of Canada is based on International Standard CEI/IEC 335-2-10:1992. 1. Scope This clause of part 1 is replaced by: This standard deals with the safety of electric floor treatment and wet scrubbing machines intended for household and similar purposes, their rated voltage being not more than 250 V. NOTES 1 Examples of floor treatment machines are…

1. Scope 1.1 This Standard applies to (a) all windows covered by CSA Standard A440, including (i) vertical sliding windows; (ii) horizontal sliding windows; (iii) tilt-and-turn windows; (iv) casement windows, both fixed and operable; (v) projecting (awning/hopper) windows; and (vi) fixed windows, including fixed-window sidelights and transom windows; (b) sliding glass doors covered…

1.1 These requirements cover the design and construction of Type L vents intended for the venting of flue gases having temperatures not exceeding 300 °C, from fuel-burning appliances certified for use with Type L vents. They may also be used where Type B gas vents are used. They are intended for installation in buildings to provide a passageway for conveying flue gases to the outer air from…

Scope 1.1 Applicability of standard to laboratory fume hoods This Standard applies to all types of laboratory fume hoods, including ductless fume hoods. Note: Ductless fume hoods should not be considered acceptable substitutes for ducted fume hoods. They may be suitable alternatives provided there is an application-specific review (i.e., risk assessment) and written approval by the…

The international community has decided to make this standard available only in the English language version. It has been adopted as a National Standard of Canada on this basis. This National Standard of Canada is equivalent to International Standard ISO/IEC 8473-1:1994. 1 Scope This Recommendation | International Standard specifies a protocol that is used to provide the…

The international community has decided to make this standard available only in the English language version. It has been adopted as a National Standard of Canada on this basis. This National Standard of Canada is equivalent to International Standard ISO/IEC 8613-8:1994. 1 Scope The purpose of the ITU-T Rec. T.410-Series | ISO/IEC 8613 is to facilitate the interchange of documents. In the…