Electric vehicle battery swap system - Part 1: General and guidance
IEC TS 62840-1:2016(E) gives the general overview for battery swap systems, for the purposes of swapping batteries of electric road vehicles (EVs) when the vehicle powertrain is turned off and when the battery swap system is connected to the supply network at standard supply voltages according to IEC 60038 with a rated voltage up to 1 000 V AC and up to 1 500 V DC. It is applicable for battery…
Road vehicles — Electrical disturbances from conduction and coupling — Part 3: Electrical transient ...
ISO 7637-3:2016 defines bench test methods to evaluate the immunity of devices under test (DUTs) to transient pulses coupled to lines other than supply lines. The test pulses simulate both fast and slow transient disturbances caused by the switching of inductive loads and relay contact bounce.
The following three test methods are described in ISO 7637-3:2016:
- capacitive coupling clamp (CCC…
Measurement of noise emitted by accelerating road vehicles — Engineering method — Part 3: Indoor tes...
ISO 362-3:2016 specifies an engineering method for measuring the noise emitted by road vehicles of categories M and N by using a semi anechoic chamber.
The specifications are intended to achieve an acoustical correlation between testing the exterior noise of road vehicles in a semi anechoic chamber and outdoor testing as described in ISO 362-1.
ISO 362-3:2016 provides all necessary specifications…
Motor vehicles for the transportation of persons with physical disabilities
1.1
This Standard applies to motor vehicles other than passenger cars (as defined in Section 2 of the Motor
Vehicle Safety Act) designed and manufactured, or converted, and equipped for the purpose of
transporting persons with physical disabilities.
1.2
This Standard specifies
a) the design and manufacture of the vehicle, lifts, and ramps;
b) the mobility aid location and securement; and…
1.1
This Standard applies to accessible over-the-road buses (OTRBs), as defined in Clause 3.
1.2
The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only.
1.3
In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply…
Intelligent transport systems — Traffic and travel information (TTI) via transport protocol experts ...
ISO/TS 21219-15:2016 specifies the TPEG application: Traffic Event Compact (TEC). The TEC application has been specifically designed to support information about traffic events (e.g. road works, traffic jams). A specific form of traffic events are local hazard warnings which, being safety-related messages, are sent with high priority to warn a driver that may encounter dangerous situations (e.g.…
Fire protection — Foam fire extinguishing systems — Part 6: Vehicle mounted compressed air foam syst...
ISO 7076-6:2016 specifies requirements for compressed air foam systems (CAFS) in which foam concentrate and compressed air are continuously added to the water being discharged from the fire-fighting pump. This part of ISO 7076 is applicable to CAFS that can be permanently installed in fire-fighting vehicles, transportable, or mobile.
ISO 7076-6:2016 specifies requirements for CAFS which are used…
