Applies to the design of highway bridges that have spans up to
l00 m, and is based upon the limit states design theory. It sets
forth minimum requirements that are consistent with current
practice. Modifications may be necessary in order to adapt the
Standard for use in the design of a specific bridge, unusual
types of bridges, and bridges with spans longer than 100 m.
Road vehicles — Transient open-loop response test method with one period of sinusoidal input
This Technical Report specifies a method for determining transient response behaviour at approximately constant speed. It is not fully representative of real driving conditions but similar to lane change manoeuvres in real traffic. Applies to passenger cars as defined in ISO 3833. In a simplified form this test method is also specified in ISO 7401 together with alternative and complementary…
1. Scope
1.1
This Standard applies to devices designed for installation on road motor
vehicles to provide a daytime running light function where the
vehicle is not factory-equipped with a daytime running light
system.
Note: This Standard has been harmonized as far as practicable with the
applicable Canadian Motor Vehicle Safety Regulations.
1.2
This Standard covers the minimum…
Road vehicles — Lateral transient response test methods
Specifies test methods to determine transient response behaviour. Applies to passenger cars as defined in ISO 3833. The measurement of steady-state properties is defined in ISO 4138. Annex A contains general data presentation; annex B gives the presentation of results. Some figures show diagrams to be reported.
Road vehicles — Nozzle spouts for leaded gasoline and diesel fuel
Specifies the dimensions of nozzle spouts on pumps for refuelling road vehicles, and their filling rates. Applies to nozzle spouts for leaded gasoline and diesel fuel for road vehicles. The figure shows a nozzle spout with a spring for safe hooking in the tank filler opening. The dimensions apply also to nozzle spouts with cams or depressions for safe hooking.
Road vehicles — Nozzle spouts for unleaded gasoline
Specifies the dimensions of nozzle spouts on pumps for refuelling road vehicles, and their filling rates. Applies to nozzle spouts for unleaded gasoline for road vehicles. The figure shows a nozzle spout with a spring for safe hooking in the tank filler opening. The dimensions apply also to nozzle spouts with cams or depressions for safe hooking.
Road vehicles — Alternators with regulators — Test methods and general requirements
Specifies test methods and general requirements for the determination of the electrical characteristic data of alternators for road vehicles. Applies to alternators, cooled according to the manufacturer's instructions, mounted on internal combustion engines. Figure 1 shows a diagram for alternator testing.
