Prefabricated Septic Tanks and Sewage Holding Tanks
1. Scope
1.1
This Standard sets out the minimum design and material requirements,
manufacturing practices, and markings for prefabricated septic tanks, sewage
holding tanks, and effluent chambers of steel, concrete, fibreglass-reinforced
plastic, or polyethylene construction designed to handle sewage or sewage
effluent.
1.2
This Standard does not purport to address all the safety…
Air quality — Determination of total non-methane organic compounds — Cryogenic preconcentration and ...
This International Standard describes a procedure for sampling and determining concentrations of total nonmethane
volatile organic compounds (NMVOC) in the ambient atmosphere.
This International Standard describes the collection of cumulative samples in passivated stainless steel canisters
and subsequent laboratory analysis. It describes a procedure for sampling in canisters at final pressures…
Packaging — Complete, filled transport packages and unit loads — Water-spray test
This International Standard specifies a method for testing the resistance of a complete, filled transport package or a
unit load to water spray or the protection it gives to its contents from water spray. It may also be used to
precondition a complete, filled transport package or a unit load prior to another test to investigate reduction in
strength caused by exposure to water.
The test is…
1. SCOPE
1.1 This standard applies to immersion suit systems that:
- reduce thermal shock upon entry into cold water;
- delay the onset of hypothermia during immersion in cold water;
- provide acceptable flotation for the wearer while in the water; and
- do not impair the wearer's ability to perform necessary abandonment…
1. SCOPE
1.1 This standard applies to a cold-curing two- or three-component epoxy
polyamide, zinc-rich coating for use as a primer or as a system for new
construction and maintenance.
1.2 The coating is intended for use on ferrous metals as a primer under
suitable topcoats or as a single or double-coat system by itself.
1.3 The testing and evaluation of a product against this…
1. SCOPE
1.1 This standard applies to immersion suit systems that:
- reduce thermal shock upon entry into cold water;
- delay the onset of hypothermia during immersion in cold water;
- provide acceptable flotation and minimize the risk of drowning; and
- do not impair the wearer's ability to evacuate from a ditched
helicopter.
1.2 The…
1. SCOPE
1.1 This standard applies to four grades of gasoline to which no lead or
phosphorus compounds have been added. They are intended for use in spark
ignition engines under a wide range of climatic conditions.
1.2 Gasoline specified in this standard may contain methyl tertiary butyl
ether (MTBE) or other aliphatic ethers.
1.3 Recommended practices for demonstrating…
Metallic and other inorganic coatings — Automated controlled shot-peening of metallic articles prior...
This International Standard describes the requirements for automated, controlled shot-peening of metallic articles
prior to electrolytic or autocatalytic deposition of nickel or chromium, or as a final finish, using shot made of cast
steel, conditioned cut wire, ceramic shot or glass beads. The process is applicable to those materials on which test
work has shown it to be beneficial within given…
1. SCOPE
1.1 This standard applies to a two-component high-build epoxy coating
suitable for application over epoxy or inorganic zinc-rich primer to provide
exterior and interior protection to steel and other surfaces, except wood,
under conditions of marine atmosphere or severe industrial environments.
1.2 This coating is intended for interior and exterior use and primarily
for…
1. SCOPE
1.1 This standard applies to a flat latex paint for most interior walls and
ceilings, with the exception of bathrooms and kitchens, either new or
previously painted.
1.2 The paint is suitable for application over all types of wall surfaces,
including wallboard, gypsum board, dry plaster, cement, brick or concrete
block.
1.3 The testing and evaluation of a product…