Rechercher

This document defines standardized and repeatable test procedures for the evaluation of blowby oil aerosol separators and filtering devices and specifies laboratory fractional separation efficiency in both open and closed crankcase ventilation systems. Filter life is not evaluated in this document. The conditioned portion of this test only applies to filters that can meet the Dp stability…

This document describes an index test procedure for simulating mechanical damage to geosynthetics, caused by granular material, under repeated loading. The damage is assessed visually and by the loss of tensile strength. Other reference tests can be used to assess the damage caused by this test. The test method described is an index test procedure, using a standard granular material, and is not…

This document covers the method for determining the setting time of concrete with slump greater than zero, by testing mortar sieved from the concrete mixture. The initial setting time and the final setting time are the time intervals required for the mortar sieved from the concrete mixture to reach the specified values of penetration resistance after the initial contact of cement and water. The…

This document specifies the general principle and the technical protocol for the validation of alternative confirmation methods for microbiology in the food chain. This document compares the result of the alternative confirmation method against the confirmation procedure of a reference method or, if needed, a reference confirmation method (e.g. whole genome sequencing). This document is…

This document defines a process to identify, assess, control, and monitor the risks associated with hazardous biological materials. This document is applicable to any laboratory or other organization that works with, stores, transports, and/or disposes of hazardous biological materials. This document is intended to complement existing International Standards for laboratories. This document is not…

This document describes the test methods used for conformity testing, that is methods for determining whether a driving licence can be considered to comply with the requirements of the ISO/IEC 18013 series for: — machine readable technologies (ISO/IEC 18013-2), and — access control, authentication and integrity validation (ISO/IEC 18013-3). The test methods described in this document are…

This document describes the test methods used for conformity testing, that is methods for determining whether a driving licence can be considered to comply with the requirements of the ISO/IEC 18013 series for: — machine readable technologies (ISO/IEC 18013-2), and — access control, authentication and integrity validation (ISO/IEC 18013-3). The test methods described in this document are…

This document specifies, for flexible and rigid cellular polymeric materials, laboratory procedures which are intended to imitate the effects of naturally occurring reactions such as oxidation or hydrolysis by humidity. The physical properties of interest are measured before and after the application of the specified treatments. Test conditions are only given for open cellular latex, both open-…

1 Scope and object This clause of Part 1 is applicable except as follows: 1.1.1 Equipment included in scope Replacement: This part of IEC 61010 specifies safety requirements for electrically powered laboratory equipment for the heating of materials, where the heating of materials is one of the functions of the equipment. NOTE If all or part of the equipment falls within the scope of one or…

1.1 Scope [Add the following] This Standard applies to the above-noted equipment that is intended to be installed or used in accordance with CSA C22.1, Canadian Electrical Code, Part I. General requirements applicable to this Standard are provided in CAN/CSA-C22.2 No. 0.