Rechercher

IEC 62246-4:2023 gives additional requirements for the evaluation of functional characteristics on reed switching components operated by magnetic actuator and gives guidance for their implementation in selected applications. This document specifies test and measurement procedures for the application of reed switch (contact) based magnetic sensors. In case the application of a reed contact…

This document specifies an apparatus and the procedures for the laboratory wet disintegration of mechanical pulps that exhibit latency except when brightness is measured. This apparatus and procedure can be used for preparation of the test portion in other International Standards dealing with pulps. This document is applicable to all kind of mechanical pulps (i.e. mechanical, semi-chemical and…

This document defines test soles representing —    an alpine ski-boot (form A) or at least the bottom part of it used for testing alpine ski-bindings for alpine skiing in accordance with ISO 9462 and ISO 9465, and —    a touring ski-boot (form T) or at least the bottom part of it used for testing touring ski-bindings for touring skiing in accordance with ISO 13992 and ISO 9465. This document also…

IEC TS 63202-3:2023 describes procedures for the measurement of current-voltage (I-V) characteristics of crystalline silicon bifacial photovoltaic (PV) cells for both laboratory and mass production applications. This document is intended to be used for measurement of individual unencapsulated bifacial PV cells, in addition to the requirements described in IEC 60904-1 and differentiating from IEC…

This document specifies the position of laboratory test specimens within a piece of leather and the method of labelling and marking the laboratory test specimens for future identification. In addition, this document specifies the design of press knives for cutting test pieces and the preparation of test pieces. It is applicable to all types of leather derived from mammals, irrespective of the…

This document provides guidance on the determination of the abrasion resistance of vulcanized and thermoplastic rubbers. It covers both solid and loose abrasives. The guidelines given are intended to assist in the selection of an appropriate test method and appropriate test conditions for evaluating a material and assessing its suitability for a product subject to abrasion. Factors influencing…

This document specifies a method for determining the amount of material passing through a sieve with 3,15-mm-diameter round holes. It is intended for use in all applications (e.g. laboratories, production sites, field locations) where the measurement of fines is required.

This standard specifies the procedure to determine the relation between the water content and the dry density of soil and soil aggregates mixes when they are compacted in a standard mould by a 2.495 kg rammer dropped from a height of 305 mm. Three methods are used to determine this relation (see Chapter 5). NOTE — The laboratory compaction test methods described in this standard generally…

This standard specifies a procedure to determine the relation between the water content and the dry density of soil and soil aggregates mixes when they are compacted in a standard mould by a 4.536 kg rammer dropped from a height of 457 mm. Three methods are used to determine this relation (see Chapter 5). NOTE — The laboratory compaction test methods described in this standard generally provide…

IEC 80601-2-59:2017+AMD1.2023 applies to the basic safety and essential performance of screening thermographs intended to be used for the individual non-invasive febrile temperature screening of a human under controlled environmental conditions, hereafter referred to as ME equipment. This document sets laboratory characterization test limits for the screening thermograph. This edition includes…