Rechercher

0 Introduction 0.1 This harmonized Standard was developed in response to an industry request for a Standard for evaluation of plastic plumbing fixtures that would be acceptable for use in both Canada and the United States. Standards for plumbing fixtures made of other materials are also available or under development. 0.2 Harmonization activities for plastic plumbing fixtures Standards were…

ISO 3691-1:2011 gives safety requirements and the means for their verification for the following types of self-propelled industrial trucks, as defined in ISO 5053: industrial counterbalanced trucks; reach trucks with retractable mast or retractable fork arm carriage; straddle trucks; pallet-stacking trucks; high-lift platform trucks; trucks with elevating operator position up to 1 200 mm; side-…

ISO 15546:2011 specifies the technical delivery conditions, manufacturing process, material requirements, configuration and dimensions, and verification and inspection procedures for aluminium alloy drill pipes with or without attached steel tool joints, for use in drilling and production operations in the petroleum and natural gas industries. A typical drill pipe configuration is provided,…

L'ISO 15546:2011 spécifie les conditions techniques de livraison, le procédé de fabrication, les exigences relatives aux matériaux, la configuration et les dimensions, les modes opératoires de vérification et d'inspection pour les tiges de forage en alliage d'aluminium, avec ou sans raccords vissés en acier, convenant à l'emploi dans les opérations de forage et de production…

ISO 13628-15:2011 addresses recommendations for subsea structures and manifolds, within the frameworks set forth by recognized and accepted industry specifications and standards. As such, it does not supersede or eliminate any requirement imposed by any other industry specification. ISO 13628-15:2011 covers subsea manifolds and templates utilized for pressure control in both subsea production of…

L'ISO 13628-15:2011 traite des recommandations relatives aux structures immergées et aux manifolds, dans les cadres définis par des spécifications et normes industrielles reconnues et acceptées. A ce titre, elle ne remplace et n'annule aucune exigence imposée par toute autre spécification industrielle. L'ISO 13628-15:2011 couvre les manifolds et templates (châssis de guidage)…

ISO 16371-1:2011 specifies fundamental parameters of computed radiography systems with the aim of enabling satisfactory and repeatable results to be obtained economically. The techniques are based both on fundamental theory and test measurements. ISO 16371-1:2011 specifies the performance of computed radiography (CR) systems and the measurement of the corresponding parameters for the system…

IEC 60335-2-95:2011 deals with the safety of electric drives for garage doors for residential use that open and close in a vertical direction, the rated voltage of the drives being not more than 250 V for single-phase appliances and 480 V for other appliances. It also covers the hazards associated with the movement of these electrically driven garage doors. This standard also applies to…

ISO 12490:2011 defines the requirements for mechanical integrity and sizing of actuators used on valves manufactured under ISO 14313 and API Specification 6D. ISO 12490:2011 is applicable to all types of electric, pneumatic and hydraulic actuators, inclusive of mounting kit, installed on pipeline valves. ISO 12490:2011 is not applicable to actuators installed on control valves, valves being used…