Rechercher

This document specifies the delivery conditions for high manganese austenitic steel in forms of hot rolled or cold rolled plates, sheets,  and coils for low temperature purposes. This document does not purport to address all the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine…

This document specifies minimum requirements for high manganese austenitic steel forgings for valves, flanges, fittings and other pressure-containing components for cryogenic temperature. The specification of high manganese austenitic steel forgings can be applicable to all pressure retaining components and any non-pressure retaining component. The selection of high manganese austenitic steel…

This document specifies minimum requirements for high manganese austenitic steel castings for valves, flanges and other pressure-containing components for cryogenic temperature. The specification of high manganese austenitic steel castings can be applicable to all pressure retaining components and any non-pressure retaining component. The selection of high manganese austenitic steel castings for…

This document specifies a method of testing the continuous wave (cw) laser resistance of the shaft of a tracheal tube and the cuff regions including the inflation system of tracheal tubes designed to resist ignition by a laser. NOTE 1 When interpreting these results, the attention of the user is drawn to the fact that the direct applicability of the results of this test method to the clinical…

ISO 13347-3:2004 applies to industrial fans as defined in ISO 5801 and ISO 13349. It is limited to the determination of airborne sound emission for the specified set-ups. Vibration is not measured, nor is the sensitivity of airborne sound emission to vibration effects determined. The sizes of fan which can be tested in accordance with ISO 13347-3:2004 are limited only by the practical aspects of…

This document specifies definitions and general requirements for cell viability analytical methods. It provides general considerations for selecting and establishing fit-for-purpose cell viability analytical methods. It also provides considerations for managing sources of variability for cell viability measurements during pre-analytical, analytical, and post-analytical phases. This document is…

This International Standard defines the procedures for noise control of mainly open plants. It is applicable to the following: _ specification of procedures for noise control during engineering of a new plant and modification/extension of existing plants (construction noise procedures are outside the scope of this International Standard but should be considered); _ definition of responsibilities…

This document defines terms within the field of electronic fee collection (EFC). This document defines: — terms within the fields of electronic fee collection and road user charging; — terms that are used in standards related to electronic fee collection; — terms of a more general use that are used more specifically in standards related to electronic fee collection. This document does…

ISO 18490:2015 specifies the form of the optotype, the quality requirements for the chart, the test procedure, and the acceptance level for near vision acuity of NDT personnel. It also addresses the qualification requirements for personnel permitted to carry out the test. ISO 18490:2015 only addresses near vision acuity under defined conditions similar to those encountered during routine NDT…