Rechercher

Scope 1.1 This Standard applies to electrically operated, general-purpose valves* and safety valves* that are intended to be used in ordinary locations in accordance with the Canadian Electrical Code, Part I, for the control of fluids (e.g., air, gases, oils, refrigerants, steam, water, etc.), and rated 600 V and less. *For convenience, the shorter term "valve" is used where the same…

1 INTRODUCTION TO THE GUIDELINE 1.1 Need for this Guideline Engineering projects in the North often encounter permafrost in their foundation environment. The ability of frozen ground to support these structures depends mostly on local climatic conditions, ground temperatures, soil/rock material properties, and ground ice conditions. Since significant climate warming is anticipated in…

ISO 15686-10:2010 establishes when to specify or verify functional performance requirements during the service life of buildings and building-related facilities, and when to check the capability of buildings and facilities to meet identified requirements. ISO 15686-10:2010 is applicable to any scope of holdings, whether a set (or portfolio) of buildings, a single building (large or small) or a…

ISO/TS 14907-1:2010 specifies the test procedures of EFC road-side equipment (RSE) and on-board equipment (OBE) with regard to the conformance to standards and requirements for type approval and acceptance testing which is within the realm of EFC application specifically. ISO/TS 14907-1:2010 is restricted to systems operating within the radio emission, EMC regulations, traffic and other…

ISO/TR 230-8:2010 is concerned with the different types of vibration that can occur between the tool-holding part and the workpiece-holding part of a machine tool. (For simplicity, these will generally be referred to as “tool” and “workpiece”, respectively.) These are vibrations that can adversely influence the production of both an acceptable surface finish and an accurate workpiece. It is not…

ISO 20685:2010 addresses protocols for the use of 3-D surface-scanning systems in the acquisition of human body shape data and measurements defined in ISO 7250-1 that can be extracted from 3-D scans. It does not apply to instruments that measure the location and/or motion of individual landmarks. While mainly concerned with whole-body scanners, it is also applicable to body-segment scanners (head…

IEC/TS 62579:2010(E) defines the conceptual model of domain management, which includes terms, requirements and reference models. The domain is a set of devices, users, and/or other entities which can share contents. Entities within a domain are allowed to play, copy and move content and usage rules to other entities within the same domain. This publication contains colours which are considered…

ISO/IEC 18051:2010 specifies the Services and Event Reports for Computer-Supported Telecommunications Applications, Phase III (CSTA). ISO/IEC 18051:2010 is focused on providing application service interfaces to a Switching Function, Computing Function and a Special Resource Function. A CSTA application interface is disassociated from the various user-network interfaces and network-network…

ISO/IEC 18051:2010 specifies the Services and Event Reports for Computer-Supported Telecommunications Applications, Phase III (CSTA). ISO/IEC 18051:2010 is focused on providing application service interfaces to a Switching Function, Computing Function and a Special Resource Function. A CSTA application interface is disassociated from the various user-network interfaces and network-network…

ISO 27407:2010 specifies a means of marking filters to communicate filter performance characteristics of interest to users. This marking can be used with either the standards referenced in ISO 27407:2010 or with any standard that has been harmonized with any referenced standard. ISO 27407:2010 applies to the marking of information only on the filter; the customer can request that the same…