Rechercher

1.1 This Standard applies to decorative gas appliances for installation in solid-fuel burning fireplaces, (see Clause 3, Definitions), hereinafter referred to as appliances, which are constructed entirely of new, unused parts and materials, and having input ratings up to and including 400,000 Btu/hr (117 228 W). These appliances are: a) for use with natural gas; b) for use with propane gas…

1.1 This Standard covers component assembly surge protective devices (SPDs) consisting of two or more Type 5 components, intended for use in Type 1, 2, or 3 SPD applications or installation in other electrical equipment. Note: SPD components containing integral thermal devices are within the scope of CSA C22.2 No. 269.5. 1.2 Type 4 component assemblies are designed for repeated limiting of…

1.1 This Standard specifies the requirements for factory made rigid polystyrene insulation in the form of boards with or without facings or coatings made by moulding of pre-expanded beads (EPS) or extrusion of polystyrene (XPS). This Standard does not apply to laminated products manufactured with any type of rigid board facer including fibreboard, perlite board, gypsum board, or oriented…

1.1 This Standard covers plastic plumbing fixtures and specifies requirements for materials, construction, performance, testing, and markings. 1.2 This Standard covers the following plumbing fixtures: a) bathtubs and combination tub/showers; b) lavatories; c) shower bases and shower stalls; d) sinks: i) bar sinks; ii) kitchen sinks; iii) laundry sinks; and iv) service sinks; e…

1.1 This Standard establishes requirements for area measurement in health care facilities (HCFs). It is intended to provide a basic, uniform system to a) support HCF planning and design activities that require such measurements (e.g., functional programming, building and room design, administration, cost estimating, and funding of capital programs); and b) facilitate meaningful comparisons…

1.1 This Standard applies to newly produced, non-recirculating direct gas-fired heating and forced ventilation appliances, hereinafter referred to as heaters, whose purpose is to address building infiltration, replace building air that is exhausted, offset building conduction heat loss and provide outside air ventilation. All air to the heater is ducted directly from outdoors and the products of…

1.1 General This Standard contains performance requirements for the material, design, marking, and testing of serially produced, refillable containers intended only for the storage of liquefied natural gas for medium- and heavy-duty vehicle operation. 1.2 Construction or materials All specifications as to construction or materials may be satisfied by any construction or materials that will…

1.1 This Standard applies to newly produced compressed Natural Gas Vehicle (NGV) fueling connection devices, hereinafter referred to as “devices”, constructed entirely of new, unused parts and materials. NGV fueling connection devices consist of the following components, as applicable: a) receptacle and protective cap (mounted on vehicle) (see Clause 4.4); b) nozzle (see Clause 4.2); and c…

1.1 This Standard applies to electric household dishwashers intended to be used in nonhazardous locations in accordance with the Canadian Electrical Code (CEC), Part I, C22.1, General Requirements – Canadian Electrical Code (CEC), Part II, C22.2, and the National Electrical Code (NEC), NFPA 70, on circuits having a nominal voltage not exceeding 250 V. 1.2 This Standard applies to both cord-…

1.1 This Standard applies to non-conductive optical fiber cable and conductive optical fiber cable intended to be installed indoors in non-hazardous locations in accordance with CSA C22.1, Canadian Electrical Code, Part I. This Standard provides performance requirements for products installed in accordance with Section 56 of the Canadian Electrical Code, Part I. 1.2 This Standard does not…